900M-T-B Soldering Tip Set 10pcs 43mm 1.2mm 200-480°C
Ten-piece set of 43 mm lead-free tips with 1.2 mm points for 200-480 °C stations including 936, 937, 938, 969, 8586 and 852D models
- Standards/CertificationsLead Free Compliant
- Lead-free compliant tips suit regulated soldering work
- Oxygen-free copper resists oxidation for 20000 joints
- Fits 936 937 938 969 8586 852D stations
- Point 1.2 mm diameter enables fine detail work
- Ten-piece set includes 900M-T-B and 900M-T-I models
10-Piece 900M Series Tip Kit
This set supplies five 900M-T-B and five 900M-T-I tips built from oxygen-free copper with a lead-free coating. Each tip handles a 200 to 480°C range and fits common 936, 937, 938, 969, 8586 and 852D stations. The T-B model measures 43 mm overall with a 1.2 mm point, while the T-I model is 4.2 cm long with a 4 mm inner bore. Together they cover general through-hole and fine-pitch work for hobbyists and repair technicians.
Two Shapes in One Pack
The T-B conical point targets precision joints and dense board layouts, while the T-I chisel profile spreads heat for larger pads and connectors. Having both profiles eliminates the need to pause and swap tips mid-session. The copper core resists oxidation past 20,000 joints, reducing tip changes and downtime. Both variants share a 6.5 mm shank and 4 mm heater bore for direct drop-in compatibility.
For Multi-Station Benches.
Workshops running several supported station models gain a single stock-keeping unit that services every iron. Technicians who only ever need one tip geometry will carry five unused spares, adding cost without benefit. Buyers with stations outside the listed 936, 937, 938, 969, 8586 and 852D families must verify fit before ordering.
Highlights
- Lead-free compliant tips suit regulated soldering work
- Oxygen-free copper resists oxidation for 20000 joints
- Fits 936 937 938 969 8586 852D stations
- Point 1.2 mm diameter enables fine detail work
- Ten-piece set includes 900M-T-B and 900M-T-I models
Specifications
| Standards/Certifications | Lead Free Compliant |
|---|
Questions about this item
How many welding joints can each tip handle before replacement?
Each tip is rated for over 20000 welding joints under normal use.
What temperature ceiling should I observe to avoid detinning?
Operate at 427 °C or lower; running above this temperature is a major cause of detinning.
How hot does the shank get during continuous operation at 480 °C?
The oxygen-free copper shank conducts heat efficiently, so the 6.5 mm shank will become very hot during extended use at the upper temperature limit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
