6 Pieces Solder Wicks Braid with Flux 0.04–0.14" 5ft Each Multi-color
Six copper braids with flux absorb solder cleanly in widths from .04 to .14 inch, each 1.5 metres long
- Standards/Certificationscopper
- Six widths from 0.04" to 0.14" cover every joint
- 5 m per roll gives 9 m total length
- No-clean flux leaves insulating residue you can skip cleaning
- Fine copper braid maximises capillary action for fast solder uptake
- Safe on delicate PCB tracks — no board damage during rework
Six-width desoldering kit
This set supplies six copper braided wicks with flux, each 1.5 metres long, covering widths from 0.04 inch to 0.14 inch. It is aimed at hobbyists, technicians and students who regularly rework small PCB assemblies and need a range of braid sizes in one pack.
Check flux compatibility and width selection
Verify that the no-clean flux residue is acceptable for your assembly standards, especially if the board must meet high-reliability cleaning requirements. Confirm that the 0.04 inch to 0.14 inch width range spans the joint sizes you encounter most often.
Sustained rework sessions
The copper construction maintains consistent capillary action during prolonged desoldering, absorbing excess solder without saturating quickly. Minimal insulating residue is left behind, so the board stays clean without interrupting workflow for frequent cleaning stops.
Highlights
- Six widths from 0.04" to 0.14" cover every joint
- 5 m per roll gives 9 m total length
- No-clean flux leaves insulating residue you can skip cleaning
- Fine copper braid maximises capillary action for fast solder uptake
- Safe on delicate PCB tracks — no board damage during rework
Specifications
| Standards/Certifications | copper |
|---|
Questions about this item
What widths of solder wick are included and how much length does each piece provide?
The pack contains six no-clean copper braids in widths of 0.04, 0.05, 0.07, 0.1, 0.12 and 0.14 inch, each 1.5 m or 5 feet long.
Which width should I choose for a specific PCB repair task?
Use the narrower 0.04 or 0.05 inch braids for fine-pitch components and the wider 0.12 or 0.14 inch braids for larger solder joints or through-hole pads.
How does the copper braid perform when removing solder from a circuit board?
The precisely woven copper improves capillary action to absorb excess solder quickly and leaves only minimal insulating residue that does not need cleaning.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
