We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four red and black needle probes with rubber handles

4 Pack 2mm Extended Needle Test Probes 600V/10A CAT II for Fluke TL71 TL75

SKU CH-JV6N-S1GPC

Four 2 mm needle probes pierce insulation for non-destructive 600 V CAT II testing with Fluke TL71 and TL75 leads

  • Features2mm Extended Needle Test Probes, Cat II 600v/10a, Other, fal
  • Sports TeamSan Francisco 49ers
  • Non-destructive wire piercing with 2 mm needle
  • CAT II 600 V 10 A rated for safe measurements
  • Premium nickel-plated copper for accurate readings
  • Compatible with Fluke TL71 and TL75 test leads
  • Four probes included for immediate multi-point testing

2 mm Extended Needle Test Probes for Fluke TL71

These probes are designed for technicians who need to pierce wire insulation without cutting it. The nickel-plated copper needles connect to Fluke TL71 or TL75 test leads and handle up to 600 V and 10 A under CAT II conditions. Four probes are supplied in red and black for clear phase identification.

Replaces standard probe tips when non-destructive

Swapping to these needles lets you reach conductors inside intact insulation, saving repair time on automotive and low-voltage control circuits. The upgrade is worthwhile whenever the circuit must stay live and resealing the jacket afterward is impractical or undesirable.

Rated for CAT II 600 V

The 3.38" overall length gives enough reach for tight harnesses while the 2 mm shank fits standard multimeter connectors and the end accepts a 4 mm banana plug. Headroom ends at the 600 V or 10 A limit; they are not suited for CAT III or CAT IV environments or for currents above the rated value.

Highlights

  • Non-destructive wire piercing with 2 mm needle
  • CAT II 600 V 10 A rated for safe measurements
  • Premium nickel-plated copper for accurate readings
  • Compatible with Fluke TL71 and TL75 test leads
  • Four probes included for immediate multi-point testing

Specifications

BrandaFe Power
Features2mm Extended Needle Test Probes, Cat II 600v/10a, Other, false
Sports TeamSan Francisco 49ers

Questions about this item

Will the 2 mm needle fit straight into a Fluke TL71 or TL75 test lead?

Yes, the 2 mm connector inserts directly into the Fluke TL71 and TL75 leads and the end also accepts a 4 mm banana plug.

What is the correct way to seat the probe so the needle does not bend?

Push the probe fully into the 2 mm socket until the handle shoulder meets the lead, then pierce the insulation with a straight, steady motion.

How often should I replace the 1.41 inch stainless needle tips?

Replace any tip that shows blunting, corrosion or a cracked nickel-plated copper shaft to maintain CAT II 600 V 10 A rating.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.