3M
3M 16054 Unitized Wheel 3 in 1/4 in 3/8 in AO Medium 12 100 RPM
Abrasive unitized wheel with aluminum oxide grain, medium grade and soft density for finishing and blending, running at 12,100 RPM
- TypeSanders
- Medium grade aluminum oxide cuts efficiently without excessive material removal
- Soft density rating conforms to contours for consistent finish on irregular surfaces
- Non-woven abrasive construction resists loading to maintain cutting performance longer
- 12, 100 RPM maximum speed suits high-speed power tool applications
- 3 inch diameter with 3/8 inch unthreaded hole fits compatible tool arbors
Abrasive wheel for light finishing
This 3M unitized wheel uses aluminum-oxide non-woven material in a medium-grade, soft-density construction. It measures three inches in diameter with a quarter-inch face width and a three-eighths-inch unthreaded centre hole. The wheel is rated for a maximum operating speed of 12,100 RPM and carries model number 16054.
Suited for blending and deburring on softer metals
The soft density and medium grade make it appropriate for cleaning, blending or light deburring where stock removal must stay minimal. It is not intended for aggressive grinding, heavy weld removal or applications that require a harder, faster-cutting abrasive.
12,100 RPM maximum speed rating
Exceeding this speed can cause the wheel to disintegrate and creates a serious safety hazard. Verify that the tool’s free speed is at or below this figure before mounting the wheel.
Highlights
- Medium grade aluminum oxide cuts efficiently without excessive material removal
- Soft density rating conforms to contours for consistent finish on irregular surfaces
- Non-woven abrasive construction resists loading to maintain cutting performance longer
- 12, 100 RPM maximum speed suits high-speed power tool applications
- 3 inch diameter with 3/8 inch unthreaded hole fits compatible tool arbors
Specifications
| Type | Sanders |
|---|---|
| Brand | 3M |
| Model | 16054 |
Questions about this item
What does 12,100 RPM mean when the wheel is running on a tool?
The wheel is rated to run safely at up to 12,100 revolutions per minute. Your tool must not exceed this speed or the wheel could fail.
How does the 3/8 inch unthreaded hole affect mounting?
The 3/8 inch unthreaded centre hole fits directly onto a matching arbor or mandrel. No threads are present, so a retaining nut or quick-change adapter is required to secure it.
Will the 3 inch diameter and 1/4 inch face width fit my sander?
The wheel measures 3 inches in overall diameter and 1/4 inch wide at the face. Check your sander’s wheel guard and spindle length to confirm it accepts these dimensions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
