3M
3M 14593 Cut and Polish Disc 3 in 10000 RPM
3 in cut and polish disc with medium-grade aluminium oxide abrasive for 10000 RPM operation
- TypeSanders
- Cuts and polishes efficiently with aluminium oxide abrasive
- Medium grade suits general surface preparation tasks
- 3 inch diameter fits compact rotary tools
- Straight 1/4 inch shaft mounts directly in standard chucks
- Rated for 10,000 RPM maximum operating speed
3 in 10,000 RPM Cut and Polish Disc
The 3M 14593 is a non-woven abrasive disc designed for surface preparation and finishing tasks. Its aluminum oxide construction suits metalwork, automotive detailing and general workshop use where controlled material removal is required. The 3-inch diameter fits standard rotary tools for precise application.
Sustained Load Behaviour
The medium-grade abrasive maintains consistent cutting action during extended use without rapid loading or glazing. Aluminum oxide grain structure resists dulling under continuous rotation at the rated 10,000 RPM maximum speed. The non-woven web construction allows debris to escape, preserving cut quality over longer sessions.
Thermals Noise and Power Draw
The straight 1/4-inch shaft transmits vibration directly to the tool motor, so perceived noise and heat depend on the drive unit rather than the disc itself. Non-woven material generates less friction heat than bonded alternatives during normal finishing passes. No independent power consumption figures exist for the consumable disc alone.
Highlights
- Cuts and polishes efficiently with aluminium oxide abrasive
- Medium grade suits general surface preparation tasks
- 3 inch diameter fits compact rotary tools
- Straight 1/4 inch shaft mounts directly in standard chucks
- Rated for 10,000 RPM maximum operating speed
Specifications
| Type | Sanders |
|---|---|
| Brand | 3M |
| Model | 14593 |
Questions about this item
Does the 3M 14593 disc run hot or draw extra power when used continuously at 10000 RPM?
The disc is a non-woven abrasive that mounts on a sander; heat and power draw depend on the tool motor and workload, not on the disc itself.
What shank size must my sander accept for the 1/4 in straight shaft on this 14593 disc?
The disc uses a 1/4 inch straight shaft, so the sander chuck or collet must grip a 1/4 inch shank.
Will this 3 in diameter disc fit the same back-up pad I use with older 3M non-woven discs?
It fits any 3 inch back-up pad designed for a 1/4 inch straight shaft; compatibility with older pads depends on that pad’s shank size and mounting style.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
