3D PERCEPTION
3D PERCEPTION Christie DS+300 OEM Philips UHP 220W Projector Lamp 2000 Hrs
A replacement lamp module with a 220 W Philips UHP bulb rated for 2,000 hours, supplied in its housing for direct installation
- TypeUHP
- Wattage220W
- Lamp Life2,000 Hrs.
- Ready to install with pre-assembled bulb and housing
- 2,000 hours of projection from 220W UHP lamp
- Manufactured to ISO 9001 quality standards
- Genuine Philips UHP bulb inside the module
- Direct OEM replacement for Christie DS+300 projectors
Genuine Philips UHP 220W Lamp
This is a new replacement projector lamp module built around a genuine Philips UHP 220W bulb. It arrives fully assembled inside its housing so installers can swap it straight into a compatible Christie DS+300 projector without extra assembly steps.
2,000-hour rated lamp life
The single specification that decides fit is the 2,000-hour rated lamp life at 220W. Buyers who need a longer service interval or a different wattage should look for an alternative module that matches their projector’s specified rating.
Runs at the rated 220W
In normal operation the lamp draws its rated 220W and meets ISO 9001 quality checks for ignition, voltage stability and run-time. The housing is designed to work with the projector’s existing cooling system, so thermal performance and acoustic output remain as the original manufacturer intended.
Highlights
- Ready to install with pre-assembled bulb and housing
- 2,000 hours of projection from 220W UHP lamp
- Manufactured to ISO 9001 quality standards
- Genuine Philips UHP bulb inside the module
- Direct OEM replacement for Christie DS+300 projectors
Specifications
| Brand | Christie |
|---|---|
| Type | UHP |
| Wattage | 220W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
What brightness can I expect from the 220W UHP bulb once installed in my Christie DS+300 projector?
The 220W Philips UHP bulb delivers the rated light output for the DS+300 when seated in the original housing, matching the projector’s factory brightness specification.
Does the lamp module use the standard Christie DS+300 connector and ignition circuit?
Yes, the fully assembled module uses the exact Christie 003-120181-01 interface, so ignition voltage and control signals are handled natively by the projector.
Will the supplied housing bolt directly into the DS+300 lamp compartment without modification?
The lamp ships as a complete bulb-and-housing unit built to the Christie 003-120181-01 mechanical spec, so it fits the existing cage and screw points.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



