Zoro Select
Zoro Select 5DTL5 Chisel Soldering Tip
A Zoro Select chisel soldering tip designed for precise heat transfer during electronic and electrical soldering tasks
- TypeChisel
- Chisel tip suits broad solder joints
- 50 mil thickness resists wear during use
- Clear polypropylene allows visual inspection
- FDA compliant for regulated environments
- 1000-piece case pack supports high-volume work
Zoro Select Chisel Soldering Tip
The Zoro Select 5DTL5 is a chisel-style soldering tip designed for general electronics assembly and repair work. Its broad, flat face transfers heat efficiently across larger joints and surface-mount pads. Technicians and hobbyists who need consistent thermal contact on through-hole leads or wider traces will find the profile practical.
Replacing worn or pointed tips
A chisel tip replaces conical or bevel tips when the task demands more surface contact and faster heat flow into the joint. The change is worth it when soldering connectors, heavier gauge wire or ground planes where a narrow point cannot deliver enough energy without dwelling too long.
Fits compatible iron barrels
The tip slides into standard barrels that accept this shank geometry, so the iron must match the manufacturer's specified interface. No additional sleeves or adapters are required when the barrel matches. The open bag packaging keeps tips organised on the bench and protects the plating until installation.
Highlights
- Chisel tip suits broad solder joints
- 50 mil thickness resists wear during use
- Clear polypropylene allows visual inspection
- FDA compliant for regulated environments
- 1000-piece case pack supports high-volume work
Specifications
| Brand | ZORO SELECT |
|---|---|
| Type | Chisel |
Questions about this item
Will the 12 in by 10 in bags fit my 10 in wide chisel soldering tip tray?
Each bag measures 12 in long by 10 in wide, so a 10 in wide tray will sit flat inside the open top.
What is the correct way to load the 1000 bags from the case pack without tearing the 1.5 mil film?
Pull one bag at a time from the flat stack; grabbing a handful stresses the thin polypropylene and causes splits.
When should I replace a bag that has been used for hot tip storage?
Discard any bag that shows melt marks, brittleness or loss of clarity after contact with a hot chisel tip.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
