Yorkplace hss2501 25mm Bi-Metal Hole Cutter pneumatic accessory
25 mm bi-metal hole cutter with M42 pilot bit cuts wood, metal, plastic and drywall
- Size/Dimensions8
- MaterialSteel
- Selling Unit1"(25MM), 1, Hole Cutter with Pilot Drill Bit
- Color/FinishRed
- Features1"(25MM)
- Item Count1, Hole Cutter with Pilot Drill Bit, 1"(25MM)
- Cuts wood, plastic and drywall cleanly with bi-metal teeth
- M42 steel centre drill resists heat for longer life
- 3/8 in shank fits most hammer drills
- Pilot bit with split tip starts holes fast
- Includes arbor, spring and hole saw in one pack
25 mm Bi-Metal Hole Cutter for Wood and Metal
The Yorkplace hss2501 is a 25 mm bi-metal hole cutter designed for cutting wood, plastic, drywall and thin metals. It includes a hole saw with M42 high-speed steel teeth and an arbor with a pilot drill bit. The shank fits a 3/8 inch or larger drill chuck. It is suited for DIY and professional use.
Users needing a single 25 mm hole cutter for mixed
This accessory suits installers and hobbyists who need one 25 mm cutter for occasional work in wood, plasterboard, plastic and thin metal sheets. It is not for buyers who need multiple diameters, deep-cutting capacity, or a cutter rated for thick steel plate. It also does not suit users whose drills only accept shanks smaller than 3/8 inch.
Arbor assembly and pilot drill alignment
Installation requires passing the pilot bit through the saw’s centre hole and rotating the arbor until the threads are fully tightened. The most common issue is loose threads between the arbor and saw, which causes wobble and tooth damage. Starting at low speed until the teeth engage helps prevent the saw from wandering.
Highlights
- Cuts wood, plastic and drywall cleanly with bi-metal teeth
- M42 steel centre drill resists heat for longer life
- 3/8 in shank fits most hammer drills
- Pilot bit with split tip starts holes fast
- Includes arbor, spring and hole saw in one pack
Specifications
| Brand | Yorkplace |
|---|---|
| Model | hss2501 |
| Size/Dimensions | 8 |
| Material | Steel |
| Selling Unit | 1"(25MM), 1, Hole Cutter with Pilot Drill Bit |
| Color/Finish | Red |
| Features | 1"(25MM) |
| Item Count | 1, Hole Cutter with Pilot Drill Bit, 1"(25MM) |
| Commercial/Residential | 1"(25MM) |
| Part Number | hss2501 |
Questions about this item
What drill chuck size do I need to fit the 3/8 inch shank on this hss2501 hole cutter?
The arbor shank is 3/8 inch, so any drill with a 3/8 inch or larger chuck will hold it securely.
Will the M42 bi-metal teeth on this 25 mm cutter still cut cleanly if I also run it in an older corded drill at lower RPM?
Yes, the M42 steel teeth keep their hardness and heat resistance at lower speeds, though you should start slowly until the teeth engage.
How can I confirm the pilot bit is centred correctly after I assemble the hss2501?
Tighten the arbor threads fully, then spin the cutter by hand; the split-tip pilot bit should run true without wobble before you apply power.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
