YINGHUA
YINGHUA Up Down Compound One Flute Spiral Carbide Mill Tool Cutter 6X22X50mm Blue
Tungsten steel compression router bit cuts acrylic, PVC, density board and wood with up-down spiral flutes, 22 mm cutting length, 50 mm overall, age 18+ industrial use
- TypeRight-Angle Drills
- Single-flute design clears chips fast for smooth cuts
- Up-down spiral compresses wood fibres to prevent tear-out
- Tungsten carbide body stays sharp through abrasive boards
- 6 mm shank fits standard CNC collets
- 22 mm cutting length handles 50 mm overall reach
YINGHUA carbide end mill 6X22X50mm
This YINGHUA up-down spiral cutter is built for CNC routing work that demands clean edges on both faces of the material. The single-flute carbide design suits hobbyists and small-shop operators cutting wood, acrylic, PVC or density board on a regular basis.
Capacity and headroom
The 22 mm cutting length and 50 mm overall length give enough reach for typical sheet-goods thicknesses while the up-down geometry compresses chips toward the centre to reduce tear-out on the top and bottom surfaces. Very thick stock or high-volume production runs will exceed the flute capacity and require a larger tool.
Build and mounting
Tungsten-steel carbide construction resists wear during abrasive composite cuts and the blue coating aids chip evacuation. The straight shank fits standard ER collets or drill chucks so the cutter can be swapped quickly on most benchtop and industrial routers. Not suited for hand-held use or for operators under 18 years of age.
Highlights
- Single-flute design clears chips fast for smooth cuts
- Up-down spiral compresses wood fibres to prevent tear-out
- Tungsten carbide body stays sharp through abrasive boards
- 6 mm shank fits standard CNC collets
- 22 mm cutting length handles 50 mm overall reach
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Will the 6 mm shank fit the collet on my older CNC router?
The cutter has a 6 mm shank; check your machine's collet specification to confirm a match.
How can I confirm the up-down spiral is cutting cleanly on my density board?
Inspect the top and bottom faces after a test pass — both should show clean edges without tear-out when the tool is working correctly.
Does the package include any collets or only the single router bit?
The box contains one up-down cut one-flute CNC router bit; collets are not included and must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
