YINGHUA
YINGHUA Two Flutes UP DOWN Cut Spiral Carbide Mill Cutter 8X42X80MM
Two-flute up-down spiral carbide cutter mills wood, plywood and particleboard with a 18 mm diameter, 42 mm flute length and 80 mm overall length
- TypeRight-Angle Drills
- Two-flute up-down spiral reduces tear-out on wood and PVC
- Tungsten-steel construction resists wear for longer cutting life
- Compression geometry clears chips efficiently in plywood and density board
- 42 mm flute length suits deep profiling in solid wood and particleboard
- 80 mm overall length fits standard CNC tool holders
Two-flute compression cutter for CNC
This tungsten-steel milling cutter uses an up-and-down spiral to shear both faces of the workpiece at once. It fits CNC routers that accept an 8 mm shank and is intended for wood, plywood, density board, solid wood and particleboard. The design reduces tear-out on laminated or veneered panels during through-cuts.
Solid carbide body with single-piece packaging
The cutter arrives in an independent package as a single unit, ready for tool-holder clamping. Tungsten-steel construction resists wear during extended production runs on abrasive sheet goods. Industrial-grade geometry means the flutes stay sharp longer than high-speed steel equivalents when cutting dense composites.
42 mm cutting length and 80 mm overall length
These dimensions determine whether the tool reaches the required depth in your fixture and clears the machine gantry. Buyers needing a longer flute reach or a shorter overall envelope for tight Z-travel should verify clearance before ordering. The 18-year age restriction also limits use to trained personnel only.
Highlights
- Two-flute up-down spiral reduces tear-out on wood and PVC
- Tungsten-steel construction resists wear for longer cutting life
- Compression geometry clears chips efficiently in plywood and density board
- 42 mm flute length suits deep profiling in solid wood and particleboard
- 80 mm overall length fits standard CNC tool holders
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 8 mm up-down spiral cutter need in a collet?
The cutter has an 8 mm shank, so it requires an 8 mm ER collet or chuck with at least 42 mm flute clearance.
How much flute length must the spindle clearance allow for this 80 mm overall tool?
The flute length is 42 mm; ensure the tool holder and workpiece fixture leave at least that much exposed length below the collet face.
Which way do the flutes face when installing this compression cutter in a CNC router?
Install with the up-cut section at the tip and down-cut section above; the transition sits at the 42 mm flute depth for clean top and bottom edges.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
