YINGHUA
YINGHUA Two Flutes UP DOWN Cut Spiral Carbide Mill Cutter 6X32X60MM
Two-flute up-down spiral carbide cutter mills wood, plywood and particleboard with 6 mm shank, 32 mm cut length and 60 mm overall length
- TypeRight-Angle Drills
- Two-flute up/down spiral reduces tear-out on both faces
- Tungsten-steel body resists wear during abrasive wood cutting
- 32 mm flute length handles deep profiles in solid timber
- 60 mm overall length fits standard CNC collets cleanly
- Single-piece pack supplies one compression cutter for plywood and particleboard
Tungsten Steel Compression Cutter
This two-flute up-and-down spiral mill is made from tungsten steel for precise CNC routing. It handles wood, plywood, density board, solid wood and particleboard in a single pass. The compression geometry reduces tear-out on both faces of the workpiece. Industrial users gain a durable replacement cutter for high-volume production.
Sustained Load Performance
The up-and-down flute design shears chips upward and downward simultaneously during extended cutting cycles. This balanced action dissipates heat and prevents material welding on the cutting edges over long runs. Tungsten steel maintains hardness at elevated temperatures better than standard carbide grades. The tool holds dimensional accuracy through repeated plunges and full-depth slots.
6 mm Shank 32 mm Cut Length
The cutter features a 6 mm shank diameter with a 32 mm cutting length and 60 mm overall length. Buyers needing a longer reach or a larger shank for heavy gantry routers cannot use this tool. It is not suited for non-ferrous metals or abrasive composites outside the listed wood-based materials. Age-restricted to users over 18 years.
Highlights
- Two-flute up/down spiral reduces tear-out on both faces
- Tungsten-steel body resists wear during abrasive wood cutting
- 32 mm flute length handles deep profiles in solid timber
- 60 mm overall length fits standard CNC collets cleanly
- Single-piece pack supplies one compression cutter for plywood and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Does the 60 mm overall length run hot or vibrate during long CNC sessions?
The tungsten-steel body dissipates heat efficiently and the balanced two-flute spiral keeps vibration low even in extended cuts.
What shank size must my collet or chuck accept for this 6 mm cutter?
The shank matches the 6 mm cutting diameter, so a standard 6 mm collet or ER collet is required.
Will this up-down compression geometry chip the edges on my older 32 mm thick plywood sheets?
The opposing flutes shear both faces cleanly, giving splinter-free edges on 32 mm plywood and similar panel materials.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
