YINGHUA
YINGHUA Two Flutes UP DOWN Cut Spiral Carbide Mill Cutter 6X22X50MM
Two-flute up-down spiral carbide cutter mills wood, plywood and particleboard in 6X22X50MM size
- TypeRight-Angle Drills
- Up-down spiral compresses wood fibres for clean edges on both faces
- Two-flute carbide geometry clears chips efficiently in plywood and density board
- Tungsten-steel body resists wear during extended CNC routing sessions
- 22 mm cutting length suits deep profiles in solid wood and particleboard
- 50 mm overall shank fits standard collets for quick tool changes
Compression Cutter for Wood and PVC
This two-flute up-and-down spiral carbide mill cutter handles wood, plywood, density board, solid wood and particleboard. The compression geometry shears the top and bottom faces simultaneously to reduce tear-out on double-sided laminates. It is intended for CNC machinery where clean edges on composite panels are required. The tungsten steel body resists wear during repetitive routing passes.
Sustained Routing Behaviour
Under continuous feed the up-and-down flute arrangement evacuates chips in both directions, preventing packing in deep slots. The carbide cutting edges maintain sharpness longer than high-speed steel when profiling abrasive materials such as particleboard. Heat distributes across the tungsten steel shank, reducing the risk of thermal expansion that can bind the tool in the cut. Consistent chip load keeps vibration low during extended profiling cycles.
6 mm Shank Diameter Decides Fit
The 6 mm shank determines whether this cutter fits your CNC collet or router chuck; verify the holder size before ordering. Cutting length is 22 mm and overall length is 50 mm, limiting the maximum depth of cut in a single pass. Buyers needing deeper pockets or larger shank diameters must select a different tool. Age restriction of 18 years applies to purchase and use.
Highlights
- Up-down spiral compresses wood fibres for clean edges on both faces
- Two-flute carbide geometry clears chips efficiently in plywood and density board
- Tungsten-steel body resists wear during extended CNC routing sessions
- 22 mm cutting length suits deep profiles in solid wood and particleboard
- 50 mm overall shank fits standard collets for quick tool changes
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How much heat does the 6 mm shank generate during long CNC runs in plywood?
Tungsten steel construction and the up-down flute geometry evacuate chips efficiently, keeping the cutter cool during extended passes in plywood and particleboard.
Which collet or chuck size is required to hold the 6 mm shank?
A standard 6 mm ER collet or 6 mm drill chuck secures the shank directly; no adapter sleeve is needed.
Will the 22 mm cutting length engage properly on a hobby CNC with limited Z travel?
The 22 mm flute length fits within most desktop CNC Z envelopes, and the 50 mm overall length leaves ample clearance for tool changes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
