YINGHUA
YINGHUA Two Flutes UP DOWN Cut Spiral Carbide Mill Cutter 4X25X45MM
Two-flute up-down spiral carbide cutter in tungsten steel compresses wood and PVC for clean CNC milling
- TypeRight-Angle Drills
- Two-flute up/down spiral gives clean compression cuts in wood and PVC
- Tungsten steel construction resists wear for long service life
- 4 mm shank with 25 mm cutting length suits detailed CNC work
- 45 mm overall length fits standard collets and tool holders
- Single-piece pack provides an immediate replacement for worn cutters
Two-flute compression cutter
This two-flute up-and-down spiral carbide mill cutter is designed for CNC machinery that requires clean edges on both faces of the workpiece. The compression geometry pushes chips away from the cut, reducing tear-out on laminated and layered materials. It suits professional woodworkers and fabricators who need precise profiling and pocketing in a single pass.
25 mm cutting length and 45 mm overall
The 25 mm flute length gives enough reach for typical sheet-goods thickness while the 45 mm overall length fits standard collets without excessive overhang. Tungsten steel construction holds an edge through abrasive composites such as particleboard and density board. The tool runs out when material thickness exceeds the flute length or when heavy hogging demands chip loads beyond the two-flute design.
Not for users under 18 years
Safety instructions restrict this bladed product to operators aged 18 and over and to industrial cutting applications only. Buyers who need a tool for hobbyist or non-industrial use, or who require a multi-piece set for varied diameters, will not be served by this single-cutter package.
Highlights
- Two-flute up/down spiral gives clean compression cuts in wood and PVC
- Tungsten steel construction resists wear for long service life
- 4 mm shank with 25 mm cutting length suits detailed CNC work
- 45 mm overall length fits standard collets and tool holders
- Single-piece pack provides an immediate replacement for worn cutters
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Will the 25 mm cutting length work with my existing CNC collet and spindle clearance?
The cutter has a 25 mm cutting length and 45 mm overall length, so check your collet capacity and Z-travel to ensure the shank seats fully without bottoming out.
How can I confirm the up-down spiral is compressing the workpiece correctly after installation?
Run a test cut in scrap plywood; a clean top and bottom edge with no tear-out shows the compression geometry is engaging properly.
Does the single-package include only the 4X25X45MM cutter or are extra shims or collets supplied?
The package contains one up-down compound milling cutter; shims, collets or tool holders must be sourced separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
