YINGHUA
YINGHUA Two Flutes UP And DOWN Cut Spiral Carbide Mill Cutters 3.175X17X38MM
Two-flute up-and-down spiral carbide cutter mills wood, plywood and particleboard with a 3.175 mm shank and 17 mm cutting length
- TypeRight-Angle Drills
- Two-flute up/down spiral gives clean compression cuts
- Tungsten steel body resists wear in abrasive materials
- 175 mm shank fits standard CNC collets
- 17 mm flute length handles deep profiling passes
- Cuts wood, plywood, density board and particleboard
Compression spiral carbide cutter
The YINGHUA two-flute up-and-down spiral mill cutter is made from tungsten steel and built for CNC machinery. Its compression geometry shears wood, plywood, density board, solid wood and particleboard cleanly from both faces. Supplied as a single cutter in independent packaging.
For clean-edged CNC routing
Suits operators who need chip-free top and bottom surfaces on sheet goods without separate roughing and finishing passes. Not intended for hand-held use, metal cutting or any application outside industrial CNC routing. Buyers requiring multiple cutters or different diameters should look elsewhere.
3.175 mm shank diameter
The 3.175 mm shank determines collet compatibility and must match the machine holder exactly. Cutting length is 17 mm and overall length is 38 mm. Verify these dimensions against your spindle and workpiece thickness before purchase.
Highlights
- Two-flute up/down spiral gives clean compression cuts
- Tungsten steel body resists wear in abrasive materials
- 175 mm shank fits standard CNC collets
- 17 mm flute length handles deep profiling passes
- Cuts wood, plywood, density board and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 3.175X17X38MM cutter need for my collet?
The cutter has a 3.175 mm shank, so use a 3.175 mm collet or an equivalent 1/8 inch collet that matches that diameter.
How do I install the up-down spiral bit without snapping the 38 mm overall length?
Insert the 3.175 mm shank fully into the collet, tighten securely, and set the plunge depth so the 17 mm cutting length engages the material without bottoming out the 38 mm tool.
When should I replace the tungsten steel cutter used on plywood and particleboard?
Replace it when the up-down flutes show visible dulling, burning on density board, or chip-out on solid wood that cleaning cannot fix.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
