YINGHUA
YINGHUA Two Flutes Straight Slot End Milling Cutter 6X6X15X50
Two-flute tungsten-steel end mill for CNC engraving wood, acrylic and plastics
- TypeRight-Angle Drills
- Two-flute design enables smooth chip evacuation for cleaner cuts
- Tungsten steel construction provides high hardness for extended tool life
- 15 mm cutting length suits detailed engraving work in wood and plastics
- Suitable for acrylic, PVC, nylon, resin, wood and plywood applications
- Industrial-grade cutter intended for users aged 18 and above
What this cutter does
The YINGHUA two-flute carbide end mill is built for CNC engraving and fine cutting in wood, plywood, acrylic, PVC, nylon and resin. Its straight-slot geometry and tungsten steel construction give a clean, precise finish for hobbyists and light-industrial operators who need repeatable detail work.
Heat noise and power
The solid carbide body runs cool during extended routing passes and produces minimal vibration, keeping noise low on compatible CNC spindles. No external cooling is required for the listed materials, and the tool draws only the power the spindle delivers at the chosen feed rate.
When to choose this tool
This 6 mm shank cutter replaces worn or single-flute bits when finer chip evacuation and smoother edges are needed on the materials above. It is not suited for heavy hogging in hardwoods, metals or composites, and it cannot be used by anyone under 18.
Highlights
- Two-flute design enables smooth chip evacuation for cleaner cuts
- Tungsten steel construction provides high hardness for extended tool life
- 15 mm cutting length suits detailed engraving work in wood and plastics
- Suitable for acrylic, PVC, nylon, resin, wood and plywood applications
- Industrial-grade cutter intended for users aged 18 and above
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I fit the 6 mm shank into my CNC router collet without run-out?
Clean the shank and collet bore, insert the shank fully, tighten the collet nut to the machine maker’s torque spec, then check for wobble before cutting.
When will the tungsten-steel flutes need replacing?
Replace the cutter when the edges dull, chip, or leave burn marks on wood, acrylic, PVC, nylon, resin or plywood.
What limits continuous cutting depth with the 15 mm flute length?
The 15 mm flute length sets the maximum depth per pass; deeper cuts need multiple passes to avoid tool deflection or breakage.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
