YINGHUA
YINGHUA Two Flutes Straight Slot End Mill 6x6x32x60 Colorful
Carbide end mill with two straight flutes for CNC engraving and cutting wood, acrylic, PVC, nylon and resin
- TypeRight-Angle Drills
- Two-flute design enables smooth chip evacuation in wood and acrylic
- 6 mm shank fits standard CNC collets for quick tool changes
- 32 mm cutting length reaches deep profiles in a single pass
- Tungsten-steel carbide construction resists wear on abrasive materials like plywood and resin
- Colour-coded coating simplifies tool identification in multi-cutter setups
6 mm shank carbide end mill
This two-flute straight-slot end mill has a 6 mm shank and 6 mm cutting diameter with a 32 mm flute length and 60 mm overall length. It is made from tungsten steel and intended for CNC engraving and cutting of acrylic, PVC, nylon, resin, wood and plywood. The tool is sold as a single piece and is not for use by anyone under 18.
Heat and power in normal use
The cutter generates heat only through material contact during milling operations. Noise and power draw depend entirely on the CNC spindle and feed rates selected by the operator. No independent thermal, acoustic or electrical ratings are supplied for the tool itself.
What the single-piece pack changes
The package contains one carbide end mill with no additional accessories, collets or software. Buyers who need multiple flutes, different diameters or a coated variant must source those separately. The single-unit format suits replacement or low-volume prototyping rather than production sets.
Highlights
- Two-flute design enables smooth chip evacuation in wood and acrylic
- 6 mm shank fits standard CNC collets for quick tool changes
- 32 mm cutting length reaches deep profiles in a single pass
- Tungsten-steel carbide construction resists wear on abrasive materials like plywood and resin
- Colour-coded coating simplifies tool identification in multi-cutter setups
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I install the 6 mm shank end mill in my CNC collet without it slipping?
Insert the 6 mm shank fully into the matching ER collet, tighten the collet nut to the manufacturer’s torque spec, and verify zero run-out before starting the spindle.
When will the tungsten-steel flutes need replacing?
Replace the cutter when the two flutes show visible rounding, chipping, or when cut quality on wood and acrylic degrades despite correct feeds and speeds.
What cutting-depth limit appears first during a long engraving job in plywood?
The 32 mm flute length sets the maximum axial depth; exceeding it forces the shank into the cut and causes deflection or tool breakage.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
