YINGHUA
YINGHUA Two Flutes Straight Slot End Mill 4X4X22X45
A two-flute carbide end mill for CNC engraving and cutting wood, acrylic, PVC, nylon and resin
- TypeRight-Angle Drills
- Two-flute design clears chips efficiently for smooth CNC engraving
- Tungsten steel construction resists wear during extended cutting sessions
- 45 mm overall length fits standard collets and tool holders
- 22 mm cutting depth handles thicker wood and acrylic stock
- Suitable for engraving acrylic, PVC, nylon, resin, wood and plywood
Tungsten-Steel End Mill for CNC Woodwork
This single-flute carbide cutter is built for CNC engraving and fine cutting in wood, plywood, acrylic, PVC, nylon and resin. The tungsten-steel construction delivers the hardness needed for clean edges and repeatable results on routing machines. It is sold as a single piece for direct replacement or small-batch tooling.
Best for Hobbyist and Light-Industrial Routing
The tool suits makers and workshops running desktop or benchtop CNC routers that need a straight-slot profile for slotting, pocketing or detailed engraving. It is not intended for heavy-duty metal milling, high-volume production lines or users who require multi-flute geometry for faster chip evacuation in tougher alloys.
Single-Piece Supply Simplifies Tool Management
Each unit ships as one cutter, so operators can replace a worn bit without committing to a multi-pack. This keeps inventory lean and lets you match the exact diameter and flute count to a specific job. No additional collets, software or accessories are included.
Highlights
- Two-flute design clears chips efficiently for smooth CNC engraving
- Tungsten steel construction resists wear during extended cutting sessions
- 45 mm overall length fits standard collets and tool holders
- 22 mm cutting depth handles thicker wood and acrylic stock
- Suitable for engraving acrylic, PVC, nylon, resin, wood and plywood
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What collet size matches the 4 mm shank on this cutter?
The shank measures 4 mm, so select a collet bored to 4 mm for a secure fit in your spindle.
Can the 22 mm flute length engage material in a shallower pocket than 22 mm?
Yes, you can plunge less than the full 22 mm flute length; the cutter will still remove material cleanly at reduced depth.
How do I verify the 45 mm overall length is seated correctly after installation?
Measure from the collet face to the cutter tip; it should read 45 mm when the shank is fully inserted and clamped.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
