YINGHUA
YINGHUA Two Flutes Straight Slot End Mill 3.175X32X55
Two-flute carbide end mill with 3.175 mm shank, 32 mm flute length and 55 mm overall length for CNC engraving in wood, acrylic, PVC and similar materials
- TypeRight-Angle Drills
- Two flutes give smooth chip clearance for clean cuts
- 175 mm shank fits standard CNC collets directly
- Tungsten steel body resists wear on abrasive materials
- 32 mm flute length reaches deep pockets in one pass
- Suitable for wood, acrylic, PVC, nylon and resin
CNC Router Bit for Wood and Plastics
This two-flute carbide end mill is built for CNC engraving and cutting in wood, plywood, acrylic, PVC, nylon and resin. The tungsten steel construction delivers a precise, easy cutting experience for detailed routing tasks. It is sold as a single piece for workshops that need a reliable replacement cutter.
Replacing Dull or Incorrect Profile Cutters
Swap this in when an existing bit leaves rough edges, burns material or cannot reach the required depth. The straight slot geometry suits 2D profiling and pocketing where a ball-nose or V-bit would produce the wrong profile. It is not for buyers who need a down-cut spiral for tear-out-free top surfaces or a compression bit for double-sided laminates.
Sustained Cutting in Abrasive Sheet Goods
Tungsten steel resists wear when routing abrasive composites such as plywood and resin-filled panels over long runs. The right-hand helix evacuates chips continuously to prevent re-cutting and heat buildup during extended toolpaths. The shank diameter matches the cutting diameter at 3.175 mm, so the tool is not for collets or holders that require a larger shank.
Highlights
- Two flutes give smooth chip clearance for clean cuts
- 175 mm shank fits standard CNC collets directly
- Tungsten steel body resists wear on abrasive materials
- 32 mm flute length reaches deep pockets in one pass
- Suitable for wood, acrylic, PVC, nylon and resin
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 3.175 mm end mill need in the collet?
The cutter has a 3.175 mm shank, so use a 3.175 mm ER collet or a matching shrink-fit holder for a secure grip.
How deep should the tool be inserted into the holder before tightening?
Push the shank in until the 32 mm flute length clears the collet face, then tighten — leaving the flutes inside the collet causes run-out and breakage.
When should the carbide cutter be replaced during wood or acrylic work?
Replace it when edges dull, chips appear on the cut surface, or vibration increases — typically after many hours in abrasive materials like plywood or resin-filled boards.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
