YINGHUA
YINGHUA Two Flutes Straight Slot End Mill 3.175X2X10X38
Tungsten steel end mill with two straight flutes for CNC engraving and cutting wood, acrylic, PVC, nylon, resin and plywood
- TypeRight-Angle Drills
- Two flutes enable smooth chip removal for clean cuts
- Tungsten steel construction resists wear during prolonged use
- 175 mm shank fits compatible CNC collets directly
- 10 mm cutting length handles shallow engraving tasks
- Suitable for wood, acrylic, PVC and similar materials
3.175 mm shank carbide end mill
This solid tungsten-steel cutter has a 3.175 mm shank, 2 mm cutting diameter, 10 mm flute length and 38 mm overall length. The two-flute straight-slot geometry evacuates chips efficiently in wood, acrylic, PVC, nylon, resin and plywood. It is sold as a single new piece for CNC engraving and fine cutting work.
Suited for CNC operators cutting soft materials
The tool is designed for engraving and light profiling in non-ferrous stock such as wood, plastics and resin. It is not intended for heavy roughing, deep pocketing or machining metals, composites or abrasive laminates that would exceed the two-flute carbide design limits. Buyers needing higher feed rates, larger diameters or coolant-through capability should select a different cutter.
2 mm cutting diameter decides fit
The 2 mm cutting diameter determines the smallest internal radius and finest detail the tool can produce. If the design requires a narrower kerf or tighter corner radius, this cutter cannot meet the requirement and a smaller-diameter end mill must be chosen.
Highlights
- Two flutes enable smooth chip removal for clean cuts
- Tungsten steel construction resists wear during prolonged use
- 175 mm shank fits compatible CNC collets directly
- 10 mm cutting length handles shallow engraving tasks
- Suitable for wood, acrylic, PVC and similar materials
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Will the 3.175 mm shank fit the collet I already use on my CNC router?
The cutter has a 3.175 mm shank diameter; it fits collets or chucks sized for that dimension.
How can I confirm the end mill is cutting correctly after installation?
Run a test engraving in wood or acrylic; clean edges and consistent chip load show the two-flute carbide cutter is working as intended.
Does the package include any collets, adapters or extra cutters?
The box contains one 3.175X2X10X38 mm carbide end mill only; collets, holders or additional tools must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
