We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A flat sensor cable set with 4-pin and 3-pin connectors on a printed circuit board

YINGHUA

YINGHUA Sensor Cable 4Pin 10.4cm 3Pin 8.5cm Printhead

SKU CH-1SRB-XAM36

Replacement sensor cable set with 10.4 cm four-pin and 8.5 cm three-pin leads for HP OfficeJet 8100, 8600, 8610, 8620, 8630, 8650, 8660 and 251DW, 276DW models

  • Product TypePrinthead
  • Compatible with HP 8600 Plus, 8610, 8650, 8660, 8630, 8100, 276DW, 251DW, 8620 printers
  • 4-pin sensor cable measures 10.4 cm for precise printhead connection
  • 3-pin sensor cable measures 8.5 cm for accurate sensor alignment
  • New condition ensures reliable performance for printer maintenance

Replacement sensor cable kit

This set provides a four-pin cable measuring 10.4 cm and a three-pin cable measuring 8.5 cm for compatible HP OfficeJet Pro printers. It suits owners of the 8600 Plus, 8610, 8620, 8630, 8650, 8660, 8100, 251DW and 276DW models who need to restore printhead communication. The cables are supplied new and ready to install.

Restores printhead signalling

The bundled four-pin and three-pin leads replace the original sensor ribbon that carries positional data from the printhead carriage to the mainboard. Fitting both cables re-establishes the closed-loop feedback required for accurate ink placement, clearing carriage-stall errors that halt printing. No additional connectors or software are included, so the repair is purely mechanical.

Highlights

  • Compatible with HP 8600 Plus, 8610, 8650, 8660, 8630, 8100, 276DW, 251DW, 8620 printers
  • 4-pin sensor cable measures 10.4 cm for precise printhead connection
  • 3-pin sensor cable measures 8.5 cm for accurate sensor alignment
  • New condition ensures reliable performance for printer maintenance

Specifications

Product TypePrinthead

Questions about this item

How often should the 4-pin 10.4 cm and 3-pin 8.5 cm sensor cables be replaced on an HP 8600 Plus?

Replace the sensor cables only if the printer reports a carriage or sensor error, or if the flex sections show visible cracks or pin corrosion; there is no scheduled interval.

What fails first when the sensor cables run continuously on an HP 8620?

The fine conductors inside the 10.4 cm 4-pin and 8.5 cm 3-pin flex cables fatigue from repeated carriage travel, causing intermittent signal loss before any other part wears out.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.