We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat ribbon cable with four pins, 0.5 cm wide and 71 cm long

YINGHUA

YINGHUA Printhead Cable GP-M832 4-pin .5cmW 71cmL

SKU CH-4AH3-N1YE0

Connects compatible printheads with a 4-pin, 0.5 cm wide, 71 cm long cable for Forepson and GP series models

  • Product TypePrinthead
  • Compatible with multiple Forepson printer models
  • 4-pin connector ensures secure printhead connection
  • 5 cm cable width fits tight printhead assemblies
  • 71 cm length provides flexible routing inside printer

Compatible Printhead Cable for GP Series

The YINGHUA GP-M832 cable connects the printhead on supported GP-series printers using a four-pin connector that is 0.5 cm wide and 71 cm long. It fits models including GP-M831, GP-C831, GP-C832, GP-M831, GP-830, M831, M830, M820, M832, GP-M830 and GP-M820. The part is supplied new and ready to install.

Replaces Damaged or Missing GP-M832 Cables

Use this cable when the original flex ribbon has failed, been severed or lost during a printhead swap on the compatible GP printers listed above. It is not suitable for printers outside the GP-M832 designation or for any device that requires a different pin count, width or length. Buyers needing a different connector layout or a longer reach should look elsewhere.

Highlights

  • Compatible with multiple Forepson printer models
  • 4-pin connector ensures secure printhead connection
  • 5 cm cable width fits tight printhead assemblies
  • 71 cm length provides flexible routing inside printer

Specifications

Product TypePrinthead

Questions about this item

What width connector does the .5 cm cable need on the printhead?

The cable uses a 4-pin connector that is .5 cm wide to match the printhead socket on compatible Forepson models.

Which end of the 71 cm cable plugs in first during installation?

Connect the 4-pin end to the printhead first, then route the 71 cm length to the mainboard connector to avoid pin misalignment.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.