YINGHUA
YINGHUA 8X35X70MM Two Flutes UP And DOWN Cut Spiral Carbide Mill Cutters 5 pieces
Five two-flute up-and-down spiral carbide cutters sized 8x35x70mm for compression cutting wood, plywood and PVC
- TypeRight-Angle Drills
- Five-piece set covers multiple jobs
- Up-and-down spiral gives clean edges on both faces
- Tungsten-steel body resists wear in abrasive materials
- 8 mm shank fits standard CNC collets
- Suited for wood, plywood, density board and particleboard
8mm Carbide Mill Cutters — 5-Piece Set
This set contains five 8×35×70 mm two-flute up-and-down cut spiral carbide mill cutters. They are made from tungsten steel for CNC machining tasks. The compression geometry suits wood, plywood, density board, solid wood and particleboard. Intended for industrial cutting only and not for users under 18 years of age.
Suitability and Limitations
These cutters suit CNC operators who need clean edges on both faces of sheet materials. They are not for hand-held routing, metal cutting or abrasive composites. Buyers needing different diameters, flute counts or shank sizes should look elsewhere.
8 mm Cutting Diameter
The cutting diameter is 8 mm with a 35 mm flute length and 70 mm overall length. This dimension decides whether the tool fits your spindle and matches the required depth of cut.
Highlights
- Five-piece set covers multiple jobs
- Up-and-down spiral gives clean edges on both faces
- Tungsten-steel body resists wear in abrasive materials
- 8 mm shank fits standard CNC collets
- Suited for wood, plywood, density board and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I install the 8 mm shank cutters in my CNC collet without vibration?
Insert the 8 mm shank fully into a matching ER collet, tighten the collet nut to the manufacturer's torque spec, and verify zero run-out before starting the spindle.
When will the tungsten steel flutes need replacement?
Replace the cutters when the up-cut and down-cut edges show visible rounding or when cut quality on plywood and density board deteriorates despite correct feed rates.
What limits continuous cutting depth in solid wood with the 35 mm flute length?
The 35 mm flute length sets the maximum single-pass depth; deeper cuts require multiple passes to avoid tool deflection and overheating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
