YINGHUA
YINGHUA 8X35X70MM Two Flutes UP And DOWN Cut Spiral Carbide Mill Cutter Bit
An 8 mm two-flute up-and-down cut carbide mill cutter bit for compression routing of wood and PVC
- TypeRight-Angle Drills
- Up-down spiral geometry gives clean edges on both faces
- Two-flute carbide design removes chips efficiently in wood and PVC
- Tungsten-steel construction resists wear for longer tool life
- 8 mm shank fits standard CNC collets without adapters
- Suitable for plywood, density board, solid wood and particleboard
8X35X70MM Compression Router Bit
This 8X35X70MM two-flute up-and-down cut spiral carbide cutter is designed for CNC routing. The tungsten steel construction resists wear while the compression geometry shears the top and bottom surfaces simultaneously. It suits wood, plywood, density board, solid wood and particleboard. Industrial cutting use only.
Who This Suits And Who Should Look Elsewhere
CNC operators who need clean edges on double-sided laminates or solid timber will benefit from the opposing helix. Buyers who require a single straight flute for chip clearance in deep slots, or who need a larger shank diameter for heavy hogging, should look elsewhere. The tool is restricted to users aged 18 and over.
Build Integration And Clearances
The cutter fits any collet or chuck that accepts an 8 mm shank and provides at least 35 mm cutting length within a 70 mm overall envelope. No specific spindle speed or feed rate is supplied, so the programmer must calculate parameters from material data. The single-piece pack keeps tool-change inventory simple.
Highlights
- Up-down spiral geometry gives clean edges on both faces
- Two-flute carbide design removes chips efficiently in wood and PVC
- Tungsten-steel construction resists wear for longer tool life
- 8 mm shank fits standard CNC collets without adapters
- Suitable for plywood, density board, solid wood and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter must my CNC collet accept for this 8 mm carbide bit?
The bit has an 8 mm shank, so your collet or chuck must grip an 8 mm diameter.
Will the up-and-down flute geometry reduce tear-out on the 35 mm cutting length when I run it on my older CNC router?
The compression design shears fibres both upward and downward along the 35 mm flute, giving clean edges on double-sided boards even with older machines.
How can I confirm the cutter is performing correctly after installation?
Check for smooth, chip-free edges on both faces of the workpiece and listen for steady, vibration-free cutting sound.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
