YINGHUA
YINGHUA 6x6x22x50 Colorful Two-Flute End Mill
A two-flute tungsten-steel end mill for engraving and cutting wood, acrylic, PVC, nylon, resin and plywood on CNC machines
- TypeRight-Angle Drills
- Precise engraving on wood and acrylic with two-flute straight-slot design
- Durable tungsten steel construction resists wear during CNC milling
- 22 mm cutting length handles deeper profiles in plywood and resin
- 50 mm overall length fits standard collets for secure toolholding
- Suitable for industrial cutting of PVC, nylon and similar materials
CNC Carbide End Mill for Wood Engraving
This two-flute straight-slot cutter is built from tungsten steel for precise CNC engraving and cutting. It handles acrylic, PVC, nylon, resin, wood and plywood in a single tool. The colorful coating aids identification in a busy workshop. It is sold as a single piece for direct replacement in compatible machines.
Thermal Behaviour and Power Draw in Normal Use
Tungsten steel construction resists heat build-up during standard engraving passes on wood or plastic. The two-flute geometry clears chips efficiently, keeping the cutting zone cooler and reducing motor load. Normal operation stays within typical spindle power envelopes for light CNC routers. Noise remains consistent with the machine spindle rather than the cutter itself.
Sustained Load Performance Over Long Cuts
Extended profiling in plywood or acrylic shows stable edge retention without rapid dulling. Chip evacuation stays effective over long tool paths, preventing re-cutting and excess friction. The tool is rated for industrial cutting only and must not be used by anyone under 18. It is not suited for heavy metal removal or high-feed roughing strategies.
Highlights
- Precise engraving on wood and acrylic with two-flute straight-slot design
- Durable tungsten steel construction resists wear during CNC milling
- 22 mm cutting length handles deeper profiles in plywood and resin
- 50 mm overall length fits standard collets for secure toolholding
- Suitable for industrial cutting of PVC, nylon and similar materials
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I install the 6 mm shank end mill in my CNC collet without damaging the tungsten steel flutes?
Insert the 6 mm shank fully into a clean ER or collet chuck rated for 6 mm, tighten evenly to the maker's torque spec, and avoid side-loading the 22 mm cutting length during the first plunge.
When will the tungsten steel flutes need replacement when cutting acrylic and plywood?
Replace the cutter when the two flutes show visible rounding or when cut quality on acrylic and plywood degrades despite correct feeds and speeds.
What limit appears first during a long engraving pass in hardwood with the 50 mm overall length?
The 22 mm flute length limits depth of cut per pass, so the tool reaches its effective cutting depth before the 50 mm overall length becomes a factor.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
