YINGHUA
YINGHUA 6x32x60mm Rainbow 3A Up Down Compound Single Flute Spiral Carbide Mill Tool Cutter
A single-flute up-down carbide cutter for clean compression cuts in wood, acrylic, PVC and density board
- TypeRight-Angle Drills
- Up-down compound flute compresses wood fibres for clean edges
- Single-flute spiral clears chips fast in acrylic and PVC
- 6 mm shank fits standard CNC collets
- 32 mm cutting length handles thick board stock
- Tungsten-steel carbide resists wear in density board and wood
CNC carbide router bit for wood and plastics
This single-flute compression cutter is built for CNC machinery and handles acrylic, PVC, density board and wood board. The tungsten-steel body provides the rigidity needed for precise profiling and through-cuts. It is intended for industrial cutting operations only and must not be used by anyone under 18 years of age.
Up-cut and down-cut geometry reduces edge tear-out
The compound spiral pulls chips upward while the down-cut section presses the top surface down, giving clean faces on both sides of the workpiece during sustained routing passes. This geometry maintains cut quality through the full 32 mm cutting length without the fraying common on single-direction bits. Heat is dissipated steadily along the carbide flute during continuous feed.
Check shank diameter and machine clearance before
The tool has a 6 mm shank and 60 mm overall length, so verify that your collet or tool holder accepts this diameter and that the Z-axis travel accommodates the full length. Ensure the spindle can run at speeds suitable for single-flute carbide in the materials you cut. This item is not designed for hand-held routers or non-industrial use.
Highlights
- Up-down compound flute compresses wood fibres for clean edges
- Single-flute spiral clears chips fast in acrylic and PVC
- 6 mm shank fits standard CNC collets
- 32 mm cutting length handles thick board stock
- Tungsten-steel carbide resists wear in density board and wood
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How much noise, heat or power does the 60 mm carbide mill tool generate during continuous CNC routing?
The solid carbide cutter produces only the sound and heat of the spindle and workpiece; it has no motor or electronics of its own.
What machine and collet must I already own to use the 6 mm shank, 32 mm flute, 60 mm overall length cutter?
You need a CNC router with a 6 mm ER collet or equivalent holder and sufficient Z travel for the 60 mm tool length.
Will the single-flute up-down geometry work alongside older straight-flute bits in the same job?
Yes, the up-down design reduces tear-out on both faces, so it can follow or precede straight-flute passes without changing feed strategy.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
