YINGHUA
YINGHUA 6X32X60MM DLC Coat Two Flutes UP DOWN Cut Spiral Carbide Mill Cutter
A single DLC-coated carbide cutter with up-and-down spiral flutes for clean compression cuts in wood and PVC
- TypeRight-Angle Drills
- DLC coating reduces friction for cleaner cuts in wood and PVC
- Up-down spiral geometry compresses chips to prevent tear-out on both faces
- Two-flute carbide design balances chip clearance with edge strength
- Tungsten steel construction maintains sharpness through abrasive materials
- 6 mm shank fits standard CNC collets for direct installation
6mm shank compression cutter for CNC wood and PVC
This carbide end mill has a 6 mm shank and 32 mm cutting length for compression milling in wood, plywood, density board, solid wood and particleboard. The up-down flute geometry shears both faces of the workpiece to reduce tear-out. It is intended for CNC machinery operators who need clean edges on double-sided panels.
DLC coating extends life under continuous routing
The diamond-like carbon coat lowers friction and resists heat build-up during long production runs on abrasive sheet goods. Two flutes evacuate chips efficiently while the up-cut and down-cut sections work together to compress fibres toward the centre. Tungsten steel substrate maintains edge rigidity when cutting dense particleboard repeatedly.
Replaces single-direction bits that leave fuzzy
Shops switching from standard up-cut or down-cut cutters gain burr-free top and bottom surfaces without a secondary finishing pass. The upgrade is worthwhile when panel throughput and edge quality outweigh the cost of a coated compression tool. Not suited for hand-held routers or metal cutting.
Highlights
- DLC coating reduces friction for cleaner cuts in wood and PVC
- Up-down spiral geometry compresses chips to prevent tear-out on both faces
- Two-flute carbide design balances chip clearance with edge strength
- Tungsten steel construction maintains sharpness through abrasive materials
- 6 mm shank fits standard CNC collets for direct installation
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How much heat does the 6 mm shank generate during continuous CNC routing?
The tungsten-steel body with DLC coating reduces friction, so heat build-up stays low even during long cutting sessions.
What collet or chuck size do I need to hold the 6 mm shank?
A standard 6 mm ER collet or 6 mm drill chuck will secure the shank without adapters.
Will the up-cut and down-cut flutes work on my older 3-axis router running at lower RPM?
Yes, the compression geometry cuts cleanly in wood, plywood and particleboard at typical hobby-router speeds.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
