YINGHUA
YINGHUA 6x32x60mm Blue 3A Up Down Single Flute Carbide Mill Cutter
A 6 mm shank carbide router bit with up-cut and down-cut flutes for clean compression cuts in wood, acrylic, PVC and density board
- TypeRight-Angle Drills
- Precise cuts on CNC machinery with tungsten steel construction
- Clean edges on acrylic, PVC, density board and wood
- Up-down spiral flute compresses material for splinter-free finish
- Single flute design clears chips efficiently during routing
- Industrial-grade cutter restricted to users aged 18 and over
Precision CNC Router Bit for Multi-Material Cutting
This single-flute carbide mill cutter is designed for CNC routing across acrylic, PVC, density board and wood board. The up-cut and down-cut geometry delivers clean edges on both faces of the workpiece. It suits workshops and production lines that need reliable compression cutting in a single pass.
Replaces Worn Standard Bits for Cleaner
Upgrade from conventional straight-flute or single-direction bits when tear-out on the top or bottom surface becomes unacceptable. The compound spiral pushes chips upward and downward simultaneously, eliminating the need for separate roughing and finishing passes on laminated panels.
Consistent Edge Quality During Extended CNC Runs
Tungsten steel construction maintains sharpness through prolonged cutting cycles, reducing tool-change frequency. The single-flute design clears chips efficiently at standard feed rates, preventing heat buildup that degrades cut quality on thermoplastic and wood-based materials.
Highlights
- Precise cuts on CNC machinery with tungsten steel construction
- Clean edges on acrylic, PVC, density board and wood
- Up-down spiral flute compresses material for splinter-free finish
- Single flute design clears chips efficiently during routing
- Industrial-grade cutter restricted to users aged 18 and over
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 6 mm cutter need in the collet?
The cutter has a 6 mm shank, so it fits a standard 6 mm ER collet or drill chuck.
How do you set the 32 mm flute length in the tool holder without bottoming out?
Insert the shank until the 32 mm cutting section clears the collet face, then tighten; the 60 mm overall length leaves room for the holder.
When should the single-flute carbide bit be replaced?
Replace it when the edge dulls on acrylic, PVC, density board or wood, or if the blue coating wears through.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
