YINGHUA
YINGHUA 6X32X60mm 3A Up Down Compound Single Flute Spiral Carbide Mill Tool Cutter
A single-flute carbide end mill with up-cut and down-cut geometry for clean compression cuts in wood, acrylic, PVC and density board
- TypeRight-Angle Drills
- Up-down compound flute compresses fibres for clean edges
- Single-flute spiral clears chips efficiently at high feed rates
- Tungsten-steel carbide body resists wear in abrasive sheet goods
- 6 mm shank fits standard ER collets and CNC routers
- Suited for acrylic, PVC, density board and wood board
Compact Carbide End Mill for CNC Woodworking
The YINGHUA 6X32X60mm single-flute compression cutter is built for CNC routers that need clean edges on both faces of the workpiece. Its up-cut and down-cut geometry pulls chips upward while pressing the top surface down, reducing tear-out on laminated boards. The solid tungsten-steel body resists wear during extended production runs. Operators must be over 18 and the tool is restricted to industrial cutting applications.
Replaces Separate Up-Cut and Down-Cut Bits
A single compression flute eliminates the need to switch between dedicated up-cut and down-cut routers when machining double-sided materials. The change is worthwhile when a job demands through-cuts on plywood, density board or solid wood without flipping the panel. It also reduces tool-change time on multi-operation programs. The cutter is not suited for metal, stone or abrasive composites that would dull the carbide quickly.
32 mm Cutting Length for Medium-Depth Passes
The 32 mm flute length provides enough engagement for typical sheet-goods thicknesses while keeping deflection low on a 6 mm shank. It handles acrylic, PVC and wood boards cleanly at standard feed rates. Deeper pockets or full-thickness cuts on stock thicker than the flute length will require multiple passes or a longer tool. The single-flute design prioritises chip evacuation over maximum material-removal rate in heavy slotting.
Highlights
- Up-down compound flute compresses fibres for clean edges
- Single-flute spiral clears chips efficiently at high feed rates
- Tungsten-steel carbide body resists wear in abrasive sheet goods
- 6 mm shank fits standard ER collets and CNC routers
- Suited for acrylic, PVC, density board and wood board
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 6X32X60mm cutter need for the collet?
The cutter has a 6 mm shank that fits a standard 6 mm ER collet or collet chuck on your CNC router spindle.
How do I install the single-flute up-down bit without snapping the carbide tip?
Insert the shank fully into the collet, tighten the collet nut to the spindle manufacturer's torque spec, and avoid side-loading the flute during the first plunge.
When should I replace the tungsten-steel compression cutter?
Replace it when the up-cut and down-cut edges show visible rounding, chipping, or when cut quality on acrylic, PVC, density board or wood board degrades noticeably.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
