YINGHUA
YINGHUA 6X15X50MM Two Flutes UP DOWN Cut Carbide End Mill Cutter
Two-flute up-down spiral carbide cutter for clean compression cuts in wood, plywood and particleboard
- TypeRight-Angle Drills
- Up-down flute design prevents tear-out on wood and PVC
- Tungsten steel construction resists wear during CNC routing
- Two-flute geometry clears chips for smoother cuts
- Suitable for plywood, density board and solid wood
- Single-piece package ready for industrial use
YINGHUA 6X15X50MM Carbide End Mill
This two-flute up-down cut carbide end mill is built from tungsten steel for CNC milling tasks. The compression spiral design shears material from both directions to reduce tear-out on the top and bottom faces. It is intended for precise profiling and slotting in wood-based panels. The cutter suits hobbyists and small-shop operators running desktop or benchtop CNC routers.
Upgrade from single-direction router bits
A single-flute or straight-flute bit pulls chips in one direction, often lifting veneers or splintering the exit surface. This up-down geometry compresses the fibres toward the centre, giving cleaner edges on double-sided laminates and plywood. The improvement is most visible when cutting 15 mm or thicker sheet goods where both faces must stay pristine. Switching makes sense when finish quality matters more than maximum material-removal rate.
Woodworkers needing clean compression cuts
The tool suits cabinet makers, sign shops and prototype builders who cut solid wood, plywood, particleboard or density board on a CNC machine. It is not for metal, stone or glass, and the shank diameter must match the collet on the spindle. Buyers who need a full set of diameters or a replaceable-insert system should look at modular tooling instead.
Highlights
- Up-down flute design prevents tear-out on wood and PVC
- Tungsten steel construction resists wear during CNC routing
- Two-flute geometry clears chips for smoother cuts
- Suitable for plywood, density board and solid wood
- Single-piece package ready for industrial use
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 6X15X50MM carbide end mill require in the collet?
The cutter has a 6 mm shank, so use a 6 mm ER collet or shrink-fit holder; the 15 mm flute length and 50 mm overall length leave enough clearance for standard tool changers.
How do I install the up-down spiral bit without chipping the tungsten-steel flutes?
Clamp the tool by the shank only, tighten the collet nut to the manufacturer’s torque spec, and avoid side-loading the 15 mm cutting zone during tool changes.
When should I replace the two-flute compression cutter used on plywood and particleboard?
Replace it when the up-cut and down-cut edges show visible rounding or when cut quality on 18 mm sheet goods degrades despite correct feed and speed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
