YINGHUA
YINGHUA 6X12X50MM Two Flutes UP DOWN Cut Spiral Carbide Mill Cutter
Two-flute up/down spiral carbide cutter compresses wood and PVC for clean edges, 6×12×50 mm shank
- TypeRight-Angle Drills
- Up-cut and down-cut flutes compress material for clean edges on both faces
- Two-flute carbide design removes chips efficiently in wood and PVC
- Tungsten steel construction resists wear during extended CNC routing sessions
- Suitable for plywood, density board, solid wood and particleboard
- Single-piece package supplies one 6x12x50 mm compression cutter ready for use
Compression cutter for wood and PVC
The YINGHUA carbide mill cutter uses an up-and-down spiral flute design to compress material from both faces during a single pass. This geometry reduces tear-out on the top and bottom surfaces of wood, plywood, density board and particleboard. The tool is intended for CNC routing rather than handheld drilling, and the package contains a single 6X12X50MM cutter.
Tungsten steel holds an edge in long runs
Tungsten steel construction resists the abrasion that dulls standard steel when cutting composite boards for hours at a time. The two-flute layout evacuates chips efficiently while the opposing helix angles keep the workpiece clamped flat, so dimensional accuracy does not drift as the spindle warms up. The cutter is rated for industrial use only and is not for anyone under 18 years of age.
Replaces separate up-cut and down-cut bits
Shops that currently switch between an up-cut bit for chip clearance and a down-cut bit for a clean top face can consolidate to this single compression tool. The change is worthwhile when a job requires clean edges on both sides of sheet goods without a secondary finishing pass. It does not suit applications that need deep plunge cuts in metal or fast material removal in soft plastics.
Highlights
- Up-cut and down-cut flutes compress material for clean edges on both faces
- Two-flute carbide design removes chips efficiently in wood and PVC
- Tungsten steel construction resists wear during extended CNC routing sessions
- Suitable for plywood, density board, solid wood and particleboard
- Single-piece package supplies one 6x12x50 mm compression cutter ready for use
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How much noise and heat does the 6 mm shank cutter generate during continuous CNC routing?
The solid carbide body runs cooler than high-speed steel, and the up-down flute geometry evacuates chips efficiently, keeping vibration and heat low during extended cuts in wood or PVC.
What collet or tool holder does the 6 mm shank require on my CNC spindle?
The 6 mm shank fits any standard 6 mm collet or ER collet system that accepts a 6 mm diameter, so the holder you already use for 6 mm tooling will work.
Will this cutter work in the same tool changer pockets as my older 6 mm end mills?
Yes, the 50 mm overall length and 6 mm shank match the envelope of common 6 mm end mills, so it occupies the same tool changer slots without adjustment.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
