YINGHUA
YINGHUA 6×22×50 mm Two-Flute Up-Down Carbide End Mill Cutter
A two-flute up-down carbide end mill for clean compression cuts in wood and PVC, 6 × 22 × 50 mm
- TypeRight-Angle Drills
- Two-flute up-down geometry gives clean edges on both faces
- 6 mm shank fits standard CNC collets without adapters
- 22 mm cutting length handles deep profiles in solid wood
- 50 mm overall length provides reach for thick workpieces
- Tungsten-steel body resists wear when routing plywood and particleboard
Industrial CNC End Mill
This single-flute carbide cutter is built for CNC routing tables that need clean compression cuts in sheet goods. The tungsten-steel body resists wear during long production runs on wood, plywood, particleboard and similar composites.
6 mm Shank Compression Geometry
The 6 mm diameter shank fits standard collets while the up-down spiral pushes chips both ways to prevent tear-out on top and bottom faces. A 22 mm cutting length and 50 mm overall length suit shallow pocketing and through-cuts without excessive overhang.
18+ Only Industrial Use
The supplier restricts this bladed tool to users aged eighteen and above and to non-hazardous industrial cutting tasks. Hobbyists without proper guarding, dust extraction or training should select a different cutter.
Highlights
- Two-flute up-down geometry gives clean edges on both faces
- 6 mm shank fits standard CNC collets without adapters
- 22 mm cutting length handles deep profiles in solid wood
- 50 mm overall length provides reach for thick workpieces
- Tungsten-steel body resists wear when routing plywood and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 6×22×50 mm cutter need to fit a collet?
The cutter has a 6 mm shank, so it requires a 6 mm collet or chuck for secure mounting.
What clearance depth does the 22 mm flute length demand from the workpiece?
The 22 mm cutting length needs at least that much clear depth below the material surface to avoid bottoming out.
How do you orient the up-down flutes when installing the bit in the router?
Insert the cutter with the up-cut section facing the shank and the down-cut section at the tip so compression action engages both surfaces.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
