YINGHUA
YINGHUA 6×22×50 mm two-flute up/down carbide end mill bits, 5 pieces
Set of five two-flute up/down carbide end mills, 6×22×50 mm, for clean compression cuts in wood and PVC
- TypeRight-Angle Drills
- 5-piece set covers multiple CNC jobs
- 6 mm shank × 22 mm cut × 50 mm overall fits standard collets
- Two-flute up/down spiral gives clean top and bottom edges
- Tungsten steel body resists wear in wood, plywood and PVC
- Single-piece packs keep each cutter protected until use
YINGHUA carbide end mill set
This set contains five two-flute carbide end mills with 6 mm shanks, 22 mm flute length and 50 mm overall length. The up-and-down spiral geometry provides compression cutting action that reduces tear-out on both faces of the workpiece. They are intended for CNC routing of wood, plywood, density board, solid wood and particleboard.
Installation and common issues
The bits fit standard 6 mm collets and install like any straight-shank router bit. Because the flutes cut in opposite directions, feed rate and spindle speed must be balanced to prevent overheating or chip welding. Running too slowly or plunging too deep in a single pass often causes vibration and premature edge wear.
Who should buy and who should not
Woodworkers and CNC operators who need clean edges on double-sided panels will benefit from the compression geometry. The set is not for buyers who need larger diameters, longer reach or specialised coatings for abrasive composites or metals. It is also unsuitable for anyone under 18 years of age.
Highlights
- 5-piece set covers multiple CNC jobs
- 6 mm shank × 22 mm cut × 50 mm overall fits standard collets
- Two-flute up/down spiral gives clean top and bottom edges
- Tungsten steel body resists wear in wood, plywood and PVC
- Single-piece packs keep each cutter protected until use
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How can I confirm the 6 mm shank end mills are cutting cleanly after installing them in my CNC?
Run a test cut in scrap wood or PVC; the up/down spiral should leave both top and bottom edges free of tear-out when the feed and speed are correct.
What exactly ships in the box and what must I supply separately?
The pack contains five 6×22×50 mm two-flute up/down carbide cutters in a single package; you provide the CNC machine, collet or holder, and workpiece material.
All five bits appear identical — is there any reason to choose one over another?
Every cutter in the set shares the same 6 mm shank, 22 mm cutting length and 50 mm overall length, so any of the five can be used for the same wood, plywood or PVC jobs.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
