YINGHUA
YINGHUA 5X22X50MM Two Flutes UP And DOWN Cut Spiral Carbide Mill Cutter
A two-flute up-and-down spiral carbide cutter for compression cutting of wood and PVC, sized 5×22×50 mm
- TypeRight-Angle Drills
- Two-flute up/down spiral cuts wood cleanly
- Tungsten steel body resists wear in dense board
- 22 mm flute length reaches deep profiles
- 50 mm overall length fits standard CNC collets
- Single-piece pack ready for immediate installation
YINGHUA Two-Flute Compression Cutter
This YINGHUA carbide mill cutter uses an up-and-down spiral design to compress wood and PVC during cutting. The 5 mm shank fits standard CNC collets and the 22 mm flute length handles typical panel thicknesses. Tungsten steel construction resists wear in abrasive sheet goods. One piece ships in a single protective package.
CNC operators cutting double-faced panels
Woodworkers who need clean top and bottom edges on plywood, density board, particleboard or solid wood will benefit from the compression geometry. Buyers machining only one-sided material or very thin veneers may find a single-direction spiral more economical. The cutter is rated for industrial use only and is not intended for users under 18 years of age.
Fits 5 mm collets on CNC routers
The 50 mm overall length clears most gantry travel envelopes without requiring extra-long tool holders. Two flutes evacuate chips efficiently, reducing heat buildup in dense composites. No coolant system is mandated, freeing the builder to run dry or with a simple air blast. The right-angle drill classification confirms compatibility with standard CNC spindle interfaces.
Highlights
- Two-flute up/down spiral cuts wood cleanly
- Tungsten steel body resists wear in dense board
- 22 mm flute length reaches deep profiles
- 50 mm overall length fits standard CNC collets
- Single-piece pack ready for immediate installation
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter must my CNC collet or router chuck accept for this 5 mm cutter?
The cutter has a 5 mm shank, so the collet or chuck must grip a 5 mm diameter.
Will the up-and-down flute geometry cut cleanly on both faces of 22 mm thick plywood in a single pass?
Yes, the 22 mm flute length lets the opposing spirals shear the top and bottom surfaces of 22 mm material at once.
How can I confirm the cutter is performing as intended after the first test cut?
Inspect the cut edges — both faces should show clean, tear-free surfaces with no fuzz on wood or melting on PVC.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
