YINGHUA
YINGHUA 5x17mm UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Set of five tungsten-steel compression cutters for clean CNC routing of wood and board materials, 17 mm cutting length
- TypeRight-Angle Drills
- Tungsten steel construction resists wear during heavy milling
- Up-and-down flute geometry compresses wood fibres for clean edges
- Two-flute spiral design clears chips efficiently at speed
- Five-piece set covers repeated CNC routing jobs
- Suitable for plywood, density board and solid wood
5 mm Compression End Mills
This five-piece set contains 5 mm diameter, 17 mm flute-length carbide cutters with a two-flute up-and-down spiral geometry. They are manufactured from tungsten steel for CNC routing applications where clean top and bottom surfaces are required on sheet goods.
CNC Shops Cutting Sheet Wood
The cutters suit workshops that rout plywood, MDF, particleboard, solid wood and similar panels on a CNC router and need compression action to prevent tear-out on both faces. They are not intended for hand-held drilling, metal milling, plastics that melt easily, or any operation outside industrial wood cutting. Users under 18 years old must not handle these bladed tools.
5 mm Shank with 17 mm Cut Length
The single specification that determines fit is the 5 mm shank diameter paired with a 17 mm cutting length; your CNC collet and tool holder must accept this exact shank size and your job must require no more than this flute engagement.
Highlights
- Tungsten steel construction resists wear during heavy milling
- Up-and-down flute geometry compresses wood fibres for clean edges
- Two-flute spiral design clears chips efficiently at speed
- Five-piece set covers repeated CNC routing jobs
- Suitable for plywood, density board and solid wood
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How much heat does the 5x17mm up-and-down-cut carbide mill generate during continuous CNC routing?
The tungsten-steel cutters run cool when feed rates match the two-flute design; excessive heat only appears if the router is pushed beyond the tool's chip-load capacity.
What shank size must my CNC router's collet accept for these 5 mm diameter cutters?
Your router needs a 5 mm collet or an adapter that grips the 5 mm shank; the set includes no collets or bushings.
Will the compression flutes on these 5x17mm cutters reduce tear-out on the veneered plywood I already stock?
Yes, the opposing up-cut and down-cut flutes compress the top and bottom veneer layers toward the centre, leaving clean edges on double-sided boards.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
