YINGHUA
YINGHUA 5Pcs 6X32mm DLC UP DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Five carbide compression cutters with DLC coating for clean CNC routing of wood and board materials
- TypeRight-Angle Drills
- DLC coating reduces friction for smoother cuts
- Up-down spiral compresses fibres to prevent tear-out
- Two-flute design clears chips quickly in dense material
- Tungsten-steel body keeps edges sharp through long runs
- Five-piece set covers multiple routing jobs in one pack
Five-piece carbide milling set
This set contains five 6 mm by 32 mm two-flute spiral carbide cutters with a diamond-like carbon coating. They are designed for CNC router compression cuts in wood, plywood, density board, solid wood and particleboard. The tungsten steel construction provides hardness for clean edges in sheet goods.
DLC coating and compression geometry
The diamond-like carbon surface reduces friction and resists adhesive wear when cutting resinous or laminated panels. Up-cut and down-cut flutes combine to shear fibres in both directions, preventing tear-out on the top and bottom faces of the workpiece. This eliminates the need for separate roughing and finishing passes.
Straight shank fits standard collets
The plain shank seats directly in common ER or collet chucks without adapters. Run-out stays low when the collet is tightened evenly and the tool is balanced before use. The cutters are unsuitable for hand-held drills and must not be used by anyone under 18 years old. Industrial cutting only.
Highlights
- DLC coating reduces friction for smoother cuts
- Up-down spiral compresses fibres to prevent tear-out
- Two-flute design clears chips quickly in dense material
- Tungsten-steel body keeps edges sharp through long runs
- Five-piece set covers multiple routing jobs in one pack
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
When will the 6X32mm DLC two-flute cutters need replacement?
Replace them when the tungsten steel edges show visible wear or when cut quality on wood and plywood drops below your tolerance.
What limits continuous cutting with these compression end mills?
Heat buildup in the carbide flutes is the first limit; allow cooling intervals during long CNC router runs.
How much noise and heat do the five-piece DLC router bits generate in all-day use?
Expect typical high-speed router noise and moderate heat at the cutting zone; the DLC coating reduces friction compared with uncoated carbide.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
