YINGHUA
YINGHUA 5Pcs 6x25mm UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Five-piece tungsten-steel compression router bit set cuts wood and sheet goods cleanly on both faces
- TypeRight-Angle Drills
- Five-piece set covers multiple routing jobs
- Up-and-down compression flutes reduce tear-out on both faces
- Two-flute spiral design clears chips efficiently during cuts
- Tungsten steel construction resists wear in abrasive wood composites
- Suited for plywood, density board, solid wood and particleboard
CNC Router Compression Cutters
This five-piece set supplies 6 mm shank tungsten-steel end mills built for CNC routers. The up-and-down flute geometry compresses wood fibres from both faces to reduce tear-out on plywood, density board, solid wood and particleboard. Two flutes per cutter give a balanced chip load for clean edges on each pass.
Replaces Worn Single-Direction Bits
Standard up-cut or down-cut bits often leave fuzzy top or bottom surfaces on double-sided panels. These compression cutters eliminate that step by shearing in both directions at once. The upgrade is worthwhile when a job demands finished faces on both sides without secondary sanding or flipping the workpiece.
Sustained Cutting In Sheet Goods
Tungsten steel retains hardness through long runs in abrasive composites such as particleboard. The dual-flute design evacuates chips steadily, preventing heat build-up that can dull lesser cutters mid-job. Operators must be over 18 and the tools are intended for industrial cutting applications only.
Highlights
- Five-piece set covers multiple routing jobs
- Up-and-down compression flutes reduce tear-out on both faces
- Two-flute spiral design clears chips efficiently during cuts
- Tungsten steel construction resists wear in abrasive wood composites
- Suited for plywood, density board, solid wood and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter fits the 6 mm collet on these cutters?
The cutters have a 6 mm shank that matches a standard 6 mm ER collet or drill chuck.
How do I install the up-and-down flute cutters without snapping the carbide tips?
Insert the shank fully into the collet, tighten evenly, and start the spindle before the tool touches the workpiece.
When should I replace the tungsten-steel cutters in this 5-piece set?
Replace them when the edges dull, chip, or leave burn marks on wood, plywood or particleboard.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
