YINGHUA
YINGHUA 5Pcs 6X22mm DLC UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Five-piece tungsten-steel compression end-mill set with up-cut and down-cut geometry for clean CNC routing of wood and board materials
- TypeRight-Angle Drills
- DLC coating extends tool life on abrasive wood materials
- Up-and-down compression geometry prevents tear-out on both faces
- Two-flute spiral design clears chips for smoother cuts
- Tungsten-steel construction resists wear during prolonged routing
- Five-piece set covers multiple jobs without reordering
Precision CNC Router Bits
This five-piece set of 6X22 mm tungsten-steel compression cutters is built for CNC routers that mill wood, plywood, density board, solid wood and particleboard. The DLC coating and up-cut/down-cut geometry give clean edges on both faces of the workpiece. They suit professional woodworkers and makers who need repeatable results on sheet goods.
Upgrade From Single-Direction Bits
Standard up-cut or down-cut bits often leave tear-out on one surface, forcing extra sanding or a second pass. These compression tools combine both shear directions in one flute, so the top and bottom faces stay crisp in a single operation. The jump is worth it when you process double-sided panels or veneered stock where finish quality on both sides matters.
Sustained Cutting Behaviour
Tungsten steel retains hardness at the temperatures generated during long routing runs, so the cutting edges stay sharp through extended production batches. The two-flute design evacuates chips efficiently, reducing heat buildup and preventing re-cutting of debris. The tool is rated for industrial use only and must not be used by anyone under 18 years of age.
Highlights
- DLC coating extends tool life on abrasive wood materials
- Up-and-down compression geometry prevents tear-out on both faces
- Two-flute spiral design clears chips for smoother cuts
- Tungsten-steel construction resists wear during prolonged routing
- Five-piece set covers multiple jobs without reordering
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Will the 6 mm shank fit my CNC router collet?
The cutters have a 6 mm shank, so they fit any standard 6 mm ER collet or collet nut used on hobby and professional CNC routers.
How do I install these cutters without damaging the DLC coating?
Clean the collet and shank, insert the tool fully, then tighten the collet nut to the router manufacturer’s torque spec — over-tightening or side-loading can chip the coating.
When should I replace the cutters in this 5-piece set?
Replace a cutter when the DLC edge shows visible wear, the tool starts burning wood or plywood, or vibration increases noticeably during cuts.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
