YINGHUA
YINGHUA 5Pcs 6x22mm Blue Up Down Cut Two Flutes Spiral Carbide Mill Tool Cutters
Set of five tungsten-steel compression end mills with up-cut and down-cut flutes for clean CNC routing of wood and composite boards
- TypeRight-Angle Drills
- 5-piece set covers multiple routing tasks
- Up-down cut flutes reduce tear-out on wood surfaces
- Tungsten steel construction resists wear during heavy use
- 22 mm cutting length handles thick stock in one pass
- Suitable for plywood, solid wood and particleboard
Five-piece carbide milling set
This five-piece set supplies 6 x 22 mm up-down cut spiral carbide mill cutters for CNC routers. Tungsten steel construction gives hard-wearing edges for compression wood end-milling tasks. The cutters suit wood, plywood, density board, solid wood and particleboard. Industrial use only; not for anyone under 18 years of age.
Up-down flute geometry controls chip flow
The two-flute up-down spiral pulls chips both upward and downward to reduce tear-out on top and bottom faces. Tungsten steel resists heat build-up during continuous routing passes. Right-angle drill format fits compatible CNC tool holders without adapters. Blue coating aids visual identification in a busy tool crib.
Five cutters per pack extends uptime
Having five identical cutters in one pack lets operators swap a dull tool instantly without halting the job. No software or additional accessories are bundled with the set. The only included items are the five carbide cutters themselves. Replacements are straightforward when all flutes show equal wear.
Highlights
- 5-piece set covers multiple routing tasks
- Up-down cut flutes reduce tear-out on wood surfaces
- Tungsten steel construction resists wear during heavy use
- 22 mm cutting length handles thick stock in one pass
- Suitable for plywood, solid wood and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How do I install the 6x22mm compression cutters in my CNC router collet without vibration?
Insert the 6 mm shank fully into a matching collet, tighten evenly, and verify zero run-out before starting the spindle; the up-down flute geometry leaves no margin for a loose fit.
When will the tungsten-steel edges need replacement on plywood and particleboard?
Expect to resharpen or replace the cutters once edge rounding appears on the up-cut and down-cut flutes; frequency depends on feed rate and material density.
What cutting-depth limit appears first during a long profiling pass in solid wood?
The 22 mm flute length sets the maximum single-pass depth; exceeding it forces chips into the shank area and causes heat buildup.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
