YINGHUA
YINGHUA 5Pcs 6x12mm UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Five tungsten-steel compression cutters for clean CNC routing of wood and board materials
- TypeRight-Angle Drills
- 5-piece set covers multiple routing jobs
- Up-and-down flute geometry reduces tear-out on both faces
- Two-flute spiral design clears chips for smoother cuts
- Tungsten-steel carbide construction resists wear in abrasive wood composites
- Suited for plywood, density board, solid wood and particleboard
Five-piece carbide set
This YINGHUA set contains five up-and-down-cut spiral end mills made from tungsten steel. Each cutter has a 6 mm shank diameter and 12 mm cutting length with two flutes. The compression geometry shears wood fibres in both directions to reduce tear-out on the top and bottom faces. The tools are supplied new and ready for CNC router use.
Woodworkers needing clean edges
The cutters suit hobbyists and small-shop operators who machine solid wood, plywood, particleboard or density board on a CNC router and want chip-free surfaces without a separate finishing pass. They are not designed for metal, plastic, stone or composite materials that require different flute geometry or coatings. Buyers who need larger diameters, longer reach or single-flute tools for chip evacuation in deep slots should look at other options.
Tungsten steel compression cutters
Tungsten steel construction gives the hardness and wear resistance required for abrasive wood-based panels. The up-and-down flute arrangement compresses chips toward the centre of the cut, producing clean edges on both faces of the workpiece in a single pass. This material and geometry combination is the decisive factor when choosing a bit for double-sided melamine, laminated plywood or solid timber where tear-out must be minimised.
Highlights
- 5-piece set covers multiple routing jobs
- Up-and-down flute geometry reduces tear-out on both faces
- Two-flute spiral design clears chips for smoother cuts
- Tungsten-steel carbide construction resists wear in abrasive wood composites
- Suited for plywood, density board, solid wood and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Does the tungsten-steel construction keep the cutters cool during long CNC runs?
Tungsten steel resists heat buildup, so the 6 mm shank cutters stay sharp and stable through extended routing sessions.
What collet size do I need on my CNC router to hold these 6 mm shanks?
A standard 6 mm ER collet or equivalent holder will secure each cutter without additional adapters.
Will these compression bits chip the edges of my existing laminate-faced particleboard?
The up-and-down flute geometry shears both faces cleanly, leaving laminate and veneer edges chip-free on particleboard and density board.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
