YINGHUA
YINGHUA 5Pcs 5x22mm UP DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Set of five tungsten-steel up/down-cut spiral router bits for clean CNC wood and board machining
- TypeRight-Angle Drills
- 5-piece set gives you ready spares for continuous CNC routing
- Up-and-down compression flutes shear top and bottom faces for clean edges in wood
- Two-flute spiral geometry clears chips efficiently during high-speed cuts
- Tungsten-steel carbide construction resists wear in plywood, density board and solid wood
- 22 mm cutting length handles thick stock in a single pass
5-Piece 5 x 22 mm Compression Router Bits
This set contains five tungsten-steel spiral cutters with a 5 mm shank and 22 mm cutting length. Each bit uses an up-and-down flute geometry that shears material in both directions for clean edges on top and bottom faces. They are designed for CNC routers handling wood-based sheet goods.
Woodworkers cutting plywood.
The compression profile suits cabinet makers and sign makers who need tear-free surfaces on double-sided panels. Hobbyists without a CNC router or those cutting metal, plastic or abrasive composites should choose different tooling.
Five matching cutters in one pack
Having identical bits on hand lets you swap a dull cutter mid-job without re-zeroing the tool length. The uniform geometry also simplifies feed-rate calculations when nesting multiple parts on a single sheet.
Highlights
- 5-piece set gives you ready spares for continuous CNC routing
- Up-and-down compression flutes shear top and bottom faces for clean edges in wood
- Two-flute spiral geometry clears chips efficiently during high-speed cuts
- Tungsten-steel carbide construction resists wear in plywood, density board and solid wood
- 22 mm cutting length handles thick stock in a single pass
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter must my CNC router's collet accept to hold these 5x22mm cutters?
The cutters have a 5 mm shank, so your collet or chuck must grip 5 mm precisely.
Will these up-down compression flutes cut cleanly in the plywood and particleboard I already machine?
Yes, the two-flute spiral is designed for wood, plywood, density board, solid wood and particleboard.
How can I confirm the cutters are performing correctly after the first test cut?
Check for clean edges on both faces of the material with no tear-out on the top or bottom surface.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
