YINGHUA
YINGHUA 5Pcs 4x17mm UP DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Set of five 4 mm by 17 mm up-down cut carbide end mills for CNC wood routing
- TypeRight-Angle Drills
- 5-piece carbide set covers multiple routing jobs
- Up-down spiral geometry shears wood fibres cleanly on both faces
- Tungsten-steel construction resists wear during extended CNC runs
- Two-flute design clears chips efficiently in plywood and particleboard
- 17 mm cutting length handles thick solid-wood and density-board stock
CNC Router Compression Cutters
This five-piece set of tungsten-steel spiral cutters is built for CNC routers that need clean edges on both faces of the workpiece. The up-down flute geometry shears the top surface downward and the bottom surface upward in a single pass.
4 mm Diameter, 17 mm Cutting Length
Each cutter has a 4 mm shank and a 17 mm flute length, giving enough reach for plywood, solid wood, particleboard and density board. The two-flute design clears chips efficiently but will run out of depth on thick hardwood slabs or deep pocketing operations.
Tungsten Steel Construction, Right-Angle Shank
Tungsten steel resists wear during long production runs on abrasive sheet goods. The right-angle shank fits standard collets without adapters, so tool changes stay quick. Not for hand-held use or operators under 18 years old.
Highlights
- 5-piece carbide set covers multiple routing jobs
- Up-down spiral geometry shears wood fibres cleanly on both faces
- Tungsten-steel construction resists wear during extended CNC runs
- Two-flute design clears chips efficiently in plywood and particleboard
- 17 mm cutting length handles thick solid-wood and density-board stock
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Will the 4 mm shank fit the collet on my older CNC router?
The cutters have a 4 mm shank diameter; check your router’s collet size to confirm compatibility.
How can I verify the up-cut and down-cut geometry is cutting cleanly?
Inspect the top and bottom faces of the workpiece — both should show smooth edges without tear-out when the tool is running correctly.
Does the five-piece set include any collets or holder adapters?
The box contains only the five 4x17 mm two-flute carbide cutters; collets and tool holders must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
