YINGHUA
YINGHUA 5Pcs 3.175x15mm UP And DOWN Cut Two Flutes Spiral Carbide Mill Tool Cutters
Set of five 3.175 mm diameter by 15 mm long up-and-down cut carbide end mills for clean CNC routing of wood and composite boards
- TypeRight-Angle Drills
- Five cutters cover multiple CNC jobs
- Up-and-down flutes compress wood fibres for clean edges
- Two-flute spiral clears chips efficiently during routing
- Tungsten steel construction resists wear on abrasive boards
- Suitable for plywood, density board and solid wood
YINGHUA 5-Piece Carbide Mill Cutters
This set contains five tungsten steel cutters sized 3.175x15mm for CNC router use. The up-and-down cut geometry with two flutes delivers clean edges on both faces of the workpiece. They are designed for precise milling of wood, plywood, density board, solid wood and particleboard. The cutters arrive new and ready for industrial cutting applications.
Upgrade From Single-Direction Bits
Standard up-cut or down-cut bits often leave tear-out on one surface of the material. These compression cutters combine both actions to eliminate that defect in a single pass. The improvement is most valuable when finish quality on both sides of the panel matters for the final product. Switching makes sense when rework or sanding time outweighs the cost of the set.
Capacity For Sheet Materials
The 15mm cutting length handles typical sheet thicknesses used in cabinet and furniture work. Tungsten steel construction maintains sharpness through repeated cuts in abrasive composites like particleboard. The tool is not suited for metals, plastics beyond wood composites, or stock thicker than the flute length. Users under 18 years must not operate these bladed cutters.
Highlights
- Five cutters cover multiple CNC jobs
- Up-and-down flutes compress wood fibres for clean edges
- Two-flute spiral clears chips efficiently during routing
- Tungsten steel construction resists wear on abrasive boards
- Suitable for plywood, density board and solid wood
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter do the 3.175 mm carbide cutters need in the collet?
The cutters have a 3.175 mm shank, so the collet must match that exact diameter.
How do I install the up-and-down compression cutters without snapping the flutes?
Insert the shank fully into the collet, tighten evenly, and start the spindle before the tool touches the workpiece.
When should I replace the tungsten-steel cutters used on plywood and particleboard?
Replace them when the edges dull, chips appear on the cut surface, or the tool overheats during routing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
