YINGHUA
YINGHUA 5pc 6x42x70mm Up/Down Cut Carbide Mill Cutters
A five-piece carbide mill cutter set with up-and-down spiral flutes for clean compression cuts in wood, plywood and PVC
- TypeRight-Angle Drills
- 5-piece set covers multiple routing tasks
- Up/down cut geometry compresses fibres for cleaner edges
- Two-flute carbide design balances chip removal and finish quality
- Tungsten steel construction resists wear in abrasive composites
- Suited for wood, plywood, density board and particleboard
Tungsten Steel Cutters for CNC
This set contains five carbide mill cutters manufactured from tungsten steel for use in CNC machinery. Each cutter measures 6x42x70mm and features a two-flute up-and-down spiral design. They are intended for compression cutting of wood, plywood, density board, solid wood and particleboard. The product is supplied new and restricted to users aged 18 and over.
Industrial Grade Carbide Construction
Tungsten steel construction provides the hardness required for industrial cutting tasks. The up-and-down flute geometry shears material in both directions to reduce tear-out on the top and bottom faces of the workpiece. Each cutter is individually packaged to protect the cutting edges during storage and handling. The right-angle drill format suits compatible CNC tool holders.
Replaces Worn Compression Bits
These cutters serve as direct replacements for dull or damaged compression end mills in a CNC setup. The five-piece quantity allows operators to rotate tools and maintain consistent cut quality across production runs. The jump is worth it when existing bits leave frayed edges on laminated sheet goods or when downtime for single-tool changes slows output. Not suited for non-wood materials or handheld routing.
Highlights
- 5-piece set covers multiple routing tasks
- Up/down cut geometry compresses fibres for cleaner edges
- Two-flute carbide design balances chip removal and finish quality
- Tungsten steel construction resists wear in abrasive composites
- Suited for wood, plywood, density board and particleboard
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank diameter does the 6 mm compression cutter need in a collet or chuck?
The cutter has a 6 mm shank, so use a 6 mm ER collet or a 6 mm three-jaw chuck; anything larger will not grip securely.
How much axial clearance is required for the 70 mm overall length?
Allow at least 70 mm from the collet face to any obstruction; the flute length is 42 mm, so the tool extends well beyond the cutting zone.
In which direction should the router spindle rotate for the up-cut flutes to pull chips upward?
Run the spindle clockwise when viewed from above; the up-cut helix then lifts chips out of the slot while the down-cut helix compresses the top surface.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
