YINGHUA
YINGHUA 5pc 6x32x60mm Up/Down Cut Carbide End Mill Set
Five-piece carbide end-mill set with up/down spiral flutes for clean compression cuts in wood, plywood and PVC
- TypeRight-Angle Drills
- Five-piece set covers multiple jobs
- 6 mm shank fits standard CNC collets
- 32 mm flute length handles deep cuts
- 60 mm overall length reaches tight areas
- Tungsten steel resists wear in wood and PVC
5-Piece Compression Carbide End Mill Set
This YINGHUA set supplies five 6x32x60 mm two-flute up-and-down cut solid carbide end mills. The compression geometry shears the top and bottom surfaces of the workpiece simultaneously, producing clean edges on double-sided material. Tungsten steel construction provides the hardness and wear resistance required for repeated CNC routing passes. Each cutter is individually packaged for protection.
For CNC operators cutting layered sheet stock
Woodworkers and fabricators who process plywood, laminates, particleboard or solid wood panels will benefit from the chip-free finish on both faces. The tools are rated for industrial use only and must not be used by anyone under 18. Shops that primarily cut single-sided boards, plastics other than PVC, or non-ferrous metals should evaluate dedicated up-cut or down-cut geometries instead.
Handles 32 mm cutting depth in wood and PVC
The 32 mm flute length allows full-depth profiling and pocketing in standard sheet thicknesses without multiple passes. Carbide retains sharpness through extended production runs in abrasive composites such as density board. The 6 mm shank diameter limits compatibility to collets or holders accepting that size, and the overall 60 mm length restricts reach in deep cavities or long-reach applications.
Highlights
- Five-piece set covers multiple jobs
- 6 mm shank fits standard CNC collets
- 32 mm flute length handles deep cuts
- 60 mm overall length reaches tight areas
- Tungsten steel resists wear in wood and PVC
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Does the 6 mm shank fit my CNC collet?
Yes, each cutter has a 6 mm shank designed for standard CNC collets.
Will the up-and-down flute geometry chip my existing plywood sheets?
The opposing flutes compress the fibres, so plywood and density board cut cleanly on both faces.
How can I verify the tungsten-steel edges stay sharp after the first job?
Inspect the cut edges — they should show no tear-out on 32 mm deep passes in solid wood.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
