YINGHUA
YINGHUA 5pc 6x25mm One Flute Up Down Cut Carbide Mill Cutters
A five-piece carbide mill-cutter set with 6 × 25 mm up/down spiral flutes for clean CNC cuts in wood, plywood and particleboard
- TypeRight-Angle Drills
- 5-piece tungsten-steel set covers multiple CNC jobs
- 6 × 25 mm single-flute geometry suits detailed routing
- Up-down spiral cut compresses wood fibres for clean edges
- Cuts plywood, density board, solid wood and particleboard
- Industrial-grade carbide resists wear during extended milling sessions
Five-piece carbide milling set
This set contains five solid-carbide cutters sized 6 by 25 millimetres. They are intended for CNC routers and similar machines that accept straight-shank end mills. Woodworkers and sign makers who need clean edges in sheet goods will find them a direct fit for compression routing tasks.
Up-down spiral for sustained cutting
The single-flute up-down geometry pushes chips both upward and downward during a pass. This compression action reduces tear-out on the top and bottom faces of plywood, density board and solid wood during long production runs. Heat stays manageable because the flute clears material continuously rather than packing it in deep slots.
Tungsten steel shank and industrial rating
Each cutter is ground from tungsten steel for wear resistance in abrasive composites such as particleboard. The package supplies five identical bits so a dull one can be swapped without stopping the job. The supplier marks the product for industrial cutting only and states it must not be used by anyone under 18 years of age.
Highlights
- 5-piece tungsten-steel set covers multiple CNC jobs
- 6 × 25 mm single-flute geometry suits detailed routing
- Up-down spiral cut compresses wood fibres for clean edges
- Cuts plywood, density board, solid wood and particleboard
- Industrial-grade carbide resists wear during extended milling sessions
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Does the tungsten steel heat up quickly when cutting plywood all day?
Tungsten steel resists heat build-up during extended cutting of plywood, density board and solid wood.
What shank size must my CNC collet accept for these 6x25 mm cutters?
The cutters have a 6 mm shank, so your collet or tool holder must grip 6 mm.
Will the up-down flute geometry tear out the top veneer on older particleboard sheets?
The up-down spiral compresses fibres from both sides, reducing tear-out on particleboard and similar materials.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
