YINGHUA
YINGHUA 5pc 4x22 One Flute Up Down Cut Carbide End Mill Bits
Five-piece carbide end-mill set with up-down spiral flutes cuts wood, plywood, density board and particleboard cleanly on CNC machines
- TypeRight-Angle Drills
- 5-piece carbide set covers multiple jobs
- One-flute up-down spiral gives clean compression cuts
- Tungsten steel construction resists wear in abrasive woods
- Suited for plywood, density board, solid wood, particleboard
- Industrial-grade cutters designed for CNC machinery use
YINGHUA 5-piece carbide mill bit set
This five-piece set supplies tungsten-steel cutters built for CNC machinery. Each bit uses a single-flute up-down spiral geometry that compresses the workpiece during cutting. The tools are intended for industrial woodworking rather than general DIY use.
4 mm shank by 22 mm cutting length
The 4 mm shank fits standard collets while the 22 mm flute handles plywood, density board, solid wood and particleboard cleanly. The up-down design reduces tear-out on both faces, though thick hardwood stock may require multiple passes to avoid overload.
Tungsten steel runs cool in wood
Carbide construction resists heat build-up during extended routing sessions, keeping the cutting edges sharp longer than high-speed steel. The single flute evacuates chips efficiently, lowering friction and motor load. Not for operators under 18 years of age.
Highlights
- 5-piece carbide set covers multiple jobs
- One-flute up-down spiral gives clean compression cuts
- Tungsten steel construction resists wear in abrasive woods
- Suited for plywood, density board, solid wood, particleboard
- Industrial-grade cutters designed for CNC machinery use
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Will the 4x22 mm shank fit the collet on my older CNC router?
The cutters have a 4 mm shank and 22 mm cutting length, so they will fit any collet or ER holder that accepts a 4 mm shank.
How can I confirm the up-down spiral is giving a clean compression cut on plywood?
After setup, run a test pocket in scrap plywood; both faces should show no tear-out if the compression geometry is working correctly.
Does the 5-piece pack include any collets, wrenches or holder adapters?
The box contains only the five carbide end mills; collets, wrenches and tool holders must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
