YINGHUA
YINGHUA 5pc 3.175x22x45mm BlueNano Compression End Mill Bits
A five-piece set of 3.175 mm shank compression end mills with 22 mm cut length and 45 mm overall length for clean cuts in wood and PVC
- TypeRight-Angle Drills
- Compression up-and-down cut prevents tear-out on wood and PVC
- Tungsten steel construction resists wear for longer tool life
- 175 mm shank fits standard CNC collets
- 22 mm cutting length handles thick panels in one pass
- Five-piece set provides ready spares for continuous production
Five-piece carbide set
This YINGHUA set supplies five 3.175 mm shank compression end mills with a 22 mm cut length and 45 mm overall length. The BlueNano coating protects the tungsten steel edges during abrasive cuts. Two-flute up-and-down spirals shear the top and bottom faces of sheet stock simultaneously. The pack is aimed at CNC operators who need a ready-to-use replacement kit.
CNC routing of wood and plastic
The cutters handle plywood, particleboard, density board and solid wood as well as PVC sheet. They are not suited for metal, composite panels or hand-held router use. Buyers who need larger diameters, longer reach or single-flute geometry for chip clearance in deep slots should look elsewhere.
3.175 mm shank diameter
The 3.175 mm shank fits collets and ER holders made for that exact size; it will not seat in 3 mm or 1/8 inch collets without an adapter. Verifying collet compatibility before purchase avoids run-out and tool breakage.
Highlights
- Compression up-and-down cut prevents tear-out on wood and PVC
- Tungsten steel construction resists wear for longer tool life
- 175 mm shank fits standard CNC collets
- 22 mm cutting length handles thick panels in one pass
- Five-piece set provides ready spares for continuous production
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How can I confirm the 3.175 mm shank end mills are cutting cleanly after installation?
Run a test cut in scrap wood or PVC and check for smooth edges without tear-out on both faces; the up-and-down flute geometry should leave a clean top and bottom surface when feed and speed are correct.
What does the 5-piece set include and is anything else required to start machining?
The box contains five 3.175x22x45 mm BlueNano compression cutters, each individually packaged; you only need a compatible CNC collet or chuck for 3.175 mm shanks.
Which of the five identical 3.175x22x45 mm cutters should I choose for my job?
All five bits share the same 3.175 mm shank, 22 mm cutting length and 45 mm overall length, so any one of them suits wood, plywood, density board, solid wood or particleboard.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
