YINGHUA
YINGHUA 5 pieces 6x22 One Flute UP DOWN Cut Spiral Carbide Mill Tool Cutters
A five-piece set of tungsten-steel compression cutters for clean CNC milling of wood, plywood and particleboard
- TypeRight-Angle Drills
- 5-piece set covers multiple CNC jobs
- Tungsten steel construction resists wear during cutting
- Up-down spiral geometry reduces tear-out on wood
- Suitable for plywood, density board and particleboard
- 22 mm cutting length handles thick stock
Five-piece carbide milling set
This five-piece set supplies tungsten-steel cutters sized 6x22 mm for CNC routing work. The single-flute up-down spiral geometry shears wood, plywood, density board, solid wood and particleboard with clean edges. Each bit is rated for industrial cutting use only. Operators must be at least 18 years old to handle the bladed tools.
Up-down spiral compression geometry
The opposing flute directions compress the workpiece from both faces, reducing tear-out on the top and bottom surfaces during through-cuts. This eliminates the need for separate up-cut and down-cut bits in many woodworking jobs. The single-flute design clears chips efficiently at high feed rates. No additional software or accessories are included in the package.
Five cutters for batch production
Five identical cutters let a shop run continuous jobs without pausing for tool changes or resharpening. The tungsten-steel substrate resists wear in abrasive sheet goods such as particleboard and MDF. The 22 mm cutting length limits depth of cut in thick solid timber. Buyers who need longer reach or multi-flute finishing profiles will need different tooling.
Highlights
- 5-piece set covers multiple CNC jobs
- Tungsten steel construction resists wear during cutting
- Up-down spiral geometry reduces tear-out on wood
- Suitable for plywood, density board and particleboard
- 22 mm cutting length handles thick stock
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
How often will the tungsten-steel cutting edges need to be replaced when machining wood and composite boards?
The carbide tips stay sharp far longer than high-speed steel, so replacement intervals are measured in many hours of cutting wood, plywood, density board, solid wood and particleboard rather than days.
What stops the 22 mm cutting length from going deeper in a single pass on dense material?
The 22 mm flute length sets the maximum depth of cut; forcing the tool deeper will cause deflection and premature wear on the tungsten-steel body.
How much heat builds up in the carbide body during continuous CNC routing of solid wood?
The single-flute up-down spiral clears chips efficiently, keeping the tungsten-steel cutter cool enough for extended runs without thermal damage to the workpiece or tool.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
