YINGHUA
YINGHUA 5 pieces 3.175X22X45MM Two Flutes UP And DOWN Cut Spiral Carbide Mill Cutters
Set of five tungsten-steel compression end mills (3.175 mm shank, 22 mm cut, 45 mm overall) for clean CNC cuts in wood and PVC
- TypeRight-Angle Drills
- Tungsten steel construction delivers long-lasting sharpness for precise CNC cuts
- Up-and-down spiral flutes compress chips to prevent tear-out on wood and PVC
- Five-piece set provides ready replacements for continuous workflow
- 175 mm shank fits standard CNC collets without adapters
- 22 mm cutting length and 45 mm overall length suit deep profiling tasks
Carbide Mill Cutter Set for CNC
This five-piece set supplies 3.175 mm shank cutters with 22 mm cutting length and 45 mm overall length. Each bit uses two-flute up-and-down spiral geometry in tungsten steel for compression cutting in wood and plastics.
Suited for CNC routing in wood composites
The cutters handle plywood, density board, solid wood and particleboard in a workshop environment. They are not intended for metal, stone or glass, nor for buyers who need different shank diameters or flute counts.
Sustained cutting in abrasive sheet goods
Tungsten steel construction resists wear during long runs in particleboard and density board. The up-and-down flute design reduces chip-out on both faces, keeping edge quality consistent through extended passes.
Highlights
- Tungsten steel construction delivers long-lasting sharpness for precise CNC cuts
- Up-and-down spiral flutes compress chips to prevent tear-out on wood and PVC
- Five-piece set provides ready replacements for continuous workflow
- 175 mm shank fits standard CNC collets without adapters
- 22 mm cutting length and 45 mm overall length suit deep profiling tasks
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
What shank size collet or chuck do I need for the 3.175 mm shank on these cutters?
You need a collet or chuck that accepts a 3.175 mm shank, which is a standard 1/8 inch size on most CNC routers and spindle motors.
Will the 22 mm cutting length reach through the material thickness I usually machine on my existing CNC router?
The 22 mm flute length limits the maximum depth of cut per pass, so ensure your workpiece thickness and Z-axis travel allow for that depth without bottoming out the 45 mm overall tool.
How can I confirm the up-cut and down-cut flutes are clearing chips cleanly after the first test cut?
Inspect the cut edges for tear-out on both faces; a clean top and bottom surface with no fuzzy fibres shows the compression geometry is evacuating chips correctly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
