YINGHUA
YINGHUA 5-piece 6x12x50mm Up/Down Carbide End Mill Set
Five carbide end mills with up-and-down flutes for clean compression cuts in wood and PVC
- TypeRight-Angle Drills
- Five-piece set covers multiple CNC jobs
- 6 mm shank, 12 mm cut, 50 mm overall length
- Up-and-down spiral compresses top and bottom surfaces
- Tungsten-steel carbide holds edge in wood and PVC
- Two-flute geometry clears chips for cleaner cuts
5-Piece Compression Carbide Set
This five-piece set supplies 6x12x50 mm two-flute up-and-down cut carbide end mills built from tungsten steel. They are intended for CNC operators and woodworkers who need clean edges on both faces of sheet material. The compression geometry shears upward and downward simultaneously, reducing tear-out on laminated and veneered panels. Industrial users over 18 will find them suited to repetitive routing tasks.
Capacity and headroom for sheet goods
The 12 mm cutting length handles plywood, density board, solid wood and particleboard in a single pass on typical panel thicknesses. Deeper pockets or thick hardwood slabs will require multiple passes or longer tooling, so the set reaches its limit on stock heavier than the flute length allows. It is not for buyers who need extended reach or larger shank diameters for heavy hogging.
Thermals noise and power draw in normal use
Solid carbide construction dissipates heat into the chips rather than the tool body, keeping the cutter stable during continuous profiling. Standard CNC spindle speeds produce typical routing noise without excessive vibration when feed rates match the two-flute design. The bits draw no power themselves; they simply transfer spindle torque into clean compression cuts.
Highlights
- Five-piece set covers multiple CNC jobs
- 6 mm shank, 12 mm cut, 50 mm overall length
- Up-and-down spiral compresses top and bottom surfaces
- Tungsten-steel carbide holds edge in wood and PVC
- Two-flute geometry clears chips for cleaner cuts
Specifications
| Type | Right-Angle Drills |
|---|
Questions about this item
Will these 50 mm long compression cutters fit in the same collet as my existing 6 mm shank bits?
Each cutter in the set has a 6 mm shank, so it fits any collet or chuck that accepts 6 mm tooling.
How can I confirm the up-cut and down-cut flutes are cutting cleanly on plywood?
Run a test pocket in scrap plywood; the up-cut flutes clear chips upward while the down-cut flutes shear the top veneer, leaving both faces tear-out free.
Does the package contain five individual cutters or a single combined tool?
The box holds five separate 6x12x50 mm two-flute up/down compression cutters, each in its own protective sleeve.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
